Ives VR900 User manual

829562_00(3) Copyright © 2003 Ingersoll-Rand. ll rights reserved.
PREPARE DOOR FOR MORTISE LOCK. SEE MORTISE
LOCK INSTRUCTIONS FOR PREPARATION.
ALIGN TRIM TEMPLATE WITH HORIZONTAL
CYLINDER CENTER LINE (C ) ON PULL SIDE EDGE
OF DOOR AND SECURE WITH TAPE.
MARK THE CENTER POINT OF EACH HOLE
WITH A PUNCH.
USING A SQUARE, TRANSFER THE 4
MOUNTING HOLE LOCATIONS TO THE
OPPOSITE SIDE OF THE DOOR.
HOLE DIMESIONS ND PREP R TION
RE SHOWN ON TEMPL TE.
LOCATE AND PREPARE ALL TRIM HOLES
AS SHOWN ON TEMPLATE.
SECURE TRIM TO PULL SIDE OF DOOR.
SEE MORTISE LOCK INSTRUCTIONS FOR
MORTISE LOCK AND CYLINDER INSTALLATION.
WHEN USING A BEVELED
DOOR, MAKE SURE TO
MEASURE HOLES FROM
THE FURTHEST EDGE AS
SHOWN
TRIM SIDE
1
2
3
4
5
6
7
RHR SHOWN
LHR OPPOSITE
VR900/VR904 TRIM
1/4 COUNTERSINK
WASHERS (4)
SCREWS (4):
1/4-20 X 1-3/8
O HMS SCREWS
(1-3/4 DOORS)
1/4-20 X 1-3/4
O HMS SCREWS
(2-1/4 DOORS)
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR RO ER FIT
CYLINDER COLLAR
VR900 TRIM
TEMPLATE
RHR SHOWN
LHR OPPOSITE
OF CYLINDER
L
C
L
INSTALLATION INSTRUCTIONS
FOR USE WITH MORTISE LOCKS (ON PULL SIDE OF DOOR)
VR900/VR904 VANDAL RESISTANT TRIM

LOCATE AND PREPARE ALL TRIM HOLES
AS SHOWN ON TEMPLATE.
SECURE TRIM TO PUSH SIDE OF DOOR.
SEE MORTISE LOCK INSTRUCTIONS FOR
MORTISE LOCK AND CYLINDER INSTALLATION.
PREPARE DOOR FOR MORTISE LOCK. SEE
MORTISE LOCK INSTRUCTIONS FOR
PREPARATION.
ALIGN TRIM TEMPLATE WITH HORIZONTAL
CYLINDER CENTER LINE (C ) ON PUSH SIDE
EDGE OF DOOR AND SECURE WITH TAPE.
MARK THE CENTER POINT OF EACH HOLE
WITH A PUNCH.
USING A SQUARE, TRANSFER THE 4
MOUNTING HOLE LOCATIONS TO THE
OPPOSITE SIDE OF THE DOOR.
HOLE DIMESIONS ND PREP R TION
RE SHOWN ON TEMPL TE.
FOR USE WITH MORTISE LOCKS (ON PUSH SIDE OF DOOR)
VR900LLP/VR904LLP VANDAL RESISTANT TRIM
WHEN USING A BEVELED
DOOR, MAKE SURE TO
MEASURE HOLES FROM
THE FURTHEST EDGE AS
SHOWN
TRIM SIDE
1
2
3
4
5
6
7
1/4 COUNTERSINK
WASHERS (4)
SCREWS (4):
1/4-20 X 1-3/8
O HMS SCREWS
(1-3/4 DOORS)
1/4-20 X 1-3/4
O HMS SCREWS
(2-1/4 DOORS)
VR900LLP/VR904LLP TRIM
LH SHOWN
RH OPPOSITE
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR RO ER FIT
CYLINDER COLLAR
LH SHOWN
RH OPPOSITE
VR900LLP TRIM
TEMPLATE
L
CYLINDER
L
C
INSTALLATION INSTRUCTIONS