J.Burrows JBMT401 User manual

1/4
Instruction Manual
J.Burrows 4-in-1 A4 Paper Cutter
JBMT401
Version: 201709
Read all instructions before use. Keep for future reference.
Officeworks Ltd. I 236-262 East Boundary Road I East Bentleigh I 3165 I AUSTRALIA
Extension Arm
Paper-clamping Bar
Cutting Head
Aluminum Tracker

2/4
J.Burrows 4-in1 Paper Cutter
Model
JBMT410
Max. paper size
A4
Cutting length
300 mm
Max cutting capacity of straight blade
5 sheets (80gsm paper)
Max cutting capacity of perforation blade
5 sheets (80gsm paper)
Max cutting capacity of wave blade
3 sheets (80gsm paper)
Max cutting capacity of score blade
3 sheets (80gsm paper)
Cutting table
300x320mm
Dimensions
390x109x56mm
Weight
0.40kgs
INSTRUCTION
Place the paper cutter on a stable flat surface. Open the lid of the cutting head.
Rotate your desired blade to the correct position as per Image 1 below.
Image 1

3/4
Note：Image 2 shows the wrong position of the blade
Image 2
Insert the paper under the transparent paper-clamping bar. Hold the cutting head as
shown in Image 3 below by clamping the lid firmly with your thumb,index finger and
middle finger. Press down the cutting head and slide the blade along the aluminum
tracker to trim the paper.
Max Capacity: 3 or 5 sheets of 80gsm paper, see page 2 for detail by blade type
Image 3

4/4
Note: Image 4 shows an incorrect way of holding the cutting head. Improper operation
may cause the blade to switch to another blade.
Image 4
NOTE
Using more than the recommended amount of paper could cause permanent
damage to the blade.
This product is intended for cutting of paper. Do not use the product for any
other purpose.
To avoid damage to the product:
Remove paper clips and staples from paper before cutting paper.
Do not expose product to humidity, water or other liquids.
To avoid possible severe personal injury:
Always operate the product on a flat, level and steady surface to avoid
overturning.
Never dismantle the cutting head by yourself.It is dangerous.