J.Burrows JBGL310 User manual

1/4
Instruction Manual
J.Burrows A3 Paper Guillotine
JBGL310
Version: 201709
Read all instructions before use. Keep for future reference.
Officeworks Ltd. I 236-262 East Boundary Road I East Bentleigh I 3165 I AUSTRALIA
Paper Stop
Transparent Blade-guard
Handle

2/4
J.Burrows Guillotine
Model
JBGL310
Max. paper size
A3
Cutting length
460mm
Max cutting capacity
(80gsm paper)
8
Cutting table
380x460mm
Dimensions
510x450x60mm
Weight
3.60kgs
INSTRUCTION
Before starting to use this paper guillotine, install the handle by rotating as shown in
image below.
Place the guillotine on a stable flat surface. Lift the blade up to its maximum position.
Place the paper on the guillotine underneath the transparent blade-guard, and then
lower the blade.

3/4
Note: Place the paper into the position as shown in images below to start cutting
paper.
MAINTENANCE
Clean guillotine with a dry cloth. Never use solvents or water. To prolong the life
of the blade, it is recommended to regularly wipe it down with silicone fluid, liquid
Vaseline or other rust-preventative oil.
Should the blade loosen, follow the 2 below steps to tighten the blade:
[A] Use a screwdriver to dismantle the grey part as shown in the image below.
[B] Use a hex screwdriver to tighten the screw bolt with one hand, while using a
wrench to hold the nut in place with the other hand. See image below.

4/4
NOTE
When not in use, the guillotine blade should be placed down (in horizontal
position).
Using more than the recommended amount of paper could cause permanent
damage to the blade.
This product is intended for cutting of paper. Do not use the product for any
other purpose.
This product is not intended for use by children. Keep product out of reach of
children.
To avoid damage to the product:
Remove paper clips and staples from paper before cutting paper.
Do not expose product to humidity, water or other liquids.
During use, the protective black coating of the blade may wear off over time.
To avoid possible severe personal injury:
Always operate the product on a flat, level and steady surface to avoid
overturning.
Always operate the guillotine with the transparent blade-guard in place.
Never carry the guillotine by the blade.
Never carry the guillotine by the cutting handle.