Jøtul GF 305 DV IPI User manual

! IMPORTANT !
UNCRATING INSTRUCTIONS
SEE STEP 2, NEXT PAGE....
Jotul North America, Inc. Gorham, Maine U.S.A.
139881 6/17
JØTUL GF 305 DV IPI
TOOLS NEEDED:
• 13 mm socket wrench with long extension
• drill-driver and #2 square head bit
• hammer
READ THIS FIRST.
STEP 1. CONFIRM LEG BOLTS ARE TIGHT.
Continuous vibration in transit can cause leg bolts to
become loose.
Before removing the stove from the pallet, use a wrench
with long extension to confirm that the leg bolts are tight.
A loose leg may also indicate shipping damage.
• Inspect sheet metal parts for dents and enamel parts
for chips and scratches.
• Report damage to your dealer.

THE STOVE BRACKETS ARE BEARING
THE WEIGHT OF THE STOVE.
STEP 2. REMOVE SHIPPING BRACKETS.
The stove is secured to the pallet and supported in transit
by two steel brackets.
CAUTION !
• Cut the wire tie to remove power cord from the bracket.
• Remove the square head screw at the foot of one bracket.

• Loosen, but DO NOT REMOVE the 13 mm
hex bolt at the keyhole slot in the Control
Compartment at the top of that bracket.
• Use the hammer to tap the slotted bracket off
of the loosened bolt.
• Repeat the process with the remaining
shipping bracket.
Control Compartment
SEE STEP 3 NEXT PAGE....

STEP 4. READ THE MANUAL.
See page 5 of the manual for further unpacking
information.
STEP 3. RE-TIGHTEN COMPARTMENT BOLTS.
CRITICAL !
While tightening the bolt, push the control
compartment back to the rear of the stove to
ensure that the bolt head remains fully-engaged
with the keyhole slot.
Push compartment back
KEYHOLE SLOT