Jabra Engage 65 User manual

How do I connect my Jabra wireless headset with the Jabra
Link 14201-17 to my Polycom desk phone so I have remote call
control using my headset?
Jabra Engage 65 Stereo
Connection:
1. Connect the AC adapter (supplied with the headset) to the headset
base, and connect the other end to an electrical outlet.
2. Connect the modular connector (supplied with the headset) to the
headset interface on your Polycom phone, and connect the end with the
blue band to the headset base socket that is marked with a phone icon.
3. Connect the Jabra Link 14201-17 EHS cable with the red band to the
AUX interface on the headset base, and connect the other end to the
AUX interface on the Polycom phone.
Configuration:
1. Ensure the “headset hook switch” function on the desk phone is set to
“Jabra EHS”. Refer to your phone or IT support for assistance.
06/04/2021 16:25
/supportpages/jabra-engage-65/9559-553-117/faq/6f849251-f166-4f92-864c-
950abfb88ccf
Page 1 of 2

2. Follow the setup instructions for your Jabra wireless headset. If the
headset base requires manual configuration, set the electronic hook
switch setting to “DHSG” and set the dial tone switch to position “A”.
3. Make a call to the headset. If the volume of your voice is too loud or
quiet to the person you are calling, adjust the headset microphone
volume until you achieve the optimum level.
06/04/2021 16:25
/supportpages/jabra-engage-65/9559-553-117/faq/6f849251-f166-4f92-864c-
950abfb88ccf
Page 2 of 2