JAMES MARTIN VANITIES 410-V30-GW User manual

Lakeside 30"Single Vanity Assembly Instructions
Page 01 of 03
410-V30-GW/410-V30-WLT
Left frame x lpc Right frame x lpc
Shelf x lpc Top metal rail x lpc Towel bar x lpc L Braket x lpc
Countertop x lpc
Front
Version:202003
Made in Vietnam
PART LIST

Lakeside 30" Single Vanity Assembly Instructions
Page 02 of 03
410-V30-GW/410-V30-WLT
F=4pcs 5/16*3-1/2
E=4pc 5/16
G=4pcs 24*24
H=1pc
B=16pcs 19
A=6pcs 5/16*1-1/2
C=16pcs 5/16
D=1pcs 5
Top metal rail
Shelf
B
B
B
C
C
C
C
A
E
A
B
D
H
D
FG
Version:202003
Made in Vietnam
Step 1:
To attach the shelf, place the shelf against the sides of frame.
Insert the bolt through the Spring Washer (C) and the Flat Wahser (B)
access the shelf and into the pri-drilled holes on the side of the frame,
the Allen Wrench needed to tighten the bolts is included.
Step 2:
To attach the metal rail, place the metal rail against the sides of frame.
Insert the bolt through the Spring Washer (C) and the Flat Wahser (B)
access the frame and into the pri-drilled holes on the side of the metal
rail, the Allen Wrench needed to tighten the bolts is included.
Step 3:
Insert the metal pad (G) into the holes on side
panel of countertop to protect any damage
on side panels during assembly.
Step 4:
Place the countertop on position, insert the Bolt (F) through the Spring
Washer (C) and Flat Washer (B) from outside, and attach the Nut (E)
with Spring Washer (C) and Flat Washer (B) from inside, tight the bolt
into the nut.

Lakeside 30" Single Vanity Assembly Instructions
Page 03 of 03
410-V30-GW/410-V30-WLT
M
=6pcs
=6pcs 4*40
I=2pcs 50*20*30
K=7pcs 4*3/4
J=2pcs 5/16*1/2
L=6pcs 23
J
L
Wall
Wall
Towel bar
K
M
C
B
I
N
N
Version:202003
Made in Vietnam
Step 5:
Place the Towel Bar and L Braket against to
the underneath of countertop, and secure
LBraket
by Screws (K) as shown in diagram.
Step 6:
Attach the L braket (I) to the top end of frame.
Note: Insert the wood caps to cover the holes on the side of frame.
NStep 7:
Drill the holes' deepth no less than 40mm on the way,
and insert "N" to the holes by using hammer, to attach
the vanity by using with Screws (M) as shown.