Janome MC 11000 - User manual

A
1, 2
B
D
C
3
E
F
F
Updating to Jump Thread Trim Mechanism
Replacing the face plate
1. Remove the 2 setscrews (A) and remove the face plate.
2. Attach the new face plate (with a brush) and secure it with
the setscrews.
Removing the tension unit
1. Remove the 3 setscrews (B) and remove the top cover.
2. Remove the 2 setscrews (C) and loosen the setscrew (D),
Remove the belt cover.
3. Remove the setscrew (E) and loosen the 3 setscrews (F) to
loosen the front cover for easy removal of the tension unit.
4. Disconnect the 2 connectors from the board-U. Remove the
2 setscrews (G) and remove the tension unit.
4
G
G
Brush
Connector
Connector

J
J
Replacing the tension guide cover
1. Remove the 2 setscrews (J) and remove the tension guide
cover.
2. Remove the rubber cushion from the tension guide cover.
Attach the rubber cushion to the new tension guide cover.
3. Attach the new tension guide cover to the tension unit and
secure it with the 2 setscrews (J).
Attaching the tension unit
1. Attach the tension unit to the machine and insert the 2
connectors to the board-U.
2. Check the tension release mechanism and adjust it if
necessary.
3. Attach the belt cover and top cover.
Replacing the thread guard
Remove the setscrew (H) and remove the thread guard.
Attach the new thread guard plate and secure it with the
setscrew (H).
H
New thread guard plate
Rubber cushion
Thread guard