Jar Furniture INDIE LW1694 User manual

INDIE
2 DRAWER BEDSIDE/LW1694
Assembly Instructions
Page 1

Page 2
2
3
56
Read Instructions carefully.
Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
WARNINGWARNING
Check no parts are missing.
4
fully tighten screws（leave slightly
loose).When the item is fully assembled
tighten the screws - but do not over tighten.
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE
THAT IS NOT COVERED BY YOUR WARRANTY
If glue is required DO NOT set until you are
certain that the parts belong together.
Page 2

Page 3
Seek advice from a qualified trades
person on how to attach this safety strap
to your specific wall.
ANTI TIPPING STICKER IS LOCATED
ON THE INSIDE OF THE TOP DRAWER
WHICH IS LOCTED ON THE LEFT
HAND SIDE CORNER
Warning Sticker
Step1
Step2
2x Timber screws
(H2)
instruction to attach the safety strap
to the back of the bedside &wall
You Will need
Screw and wall plug which are not
provided. Please use appropriate
fixture for your wall.

Page 4
Step3