Jar Furniture VICTORIA VD1679S User manual

Assembly Instructions
SIDE TABLT / VD1679S
VICTORIA

Page 2
2
3
56
Read Instructions carefully. Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
WARNINGWARNING
Check no parts are missing.
4
fully tighten screws（leave slightly
loose).When the item is fully assembled
tighten the screws - but do not over tighten.
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE
THAT IS NOT COVERED BY YOUR WARRANTY
If glue is required DO NOT set until you are
certain that the parts belong together.

Page 3
What you Need
ToAssembletheBody
Please make sure you have all these parts before you start.
(Toolsnotprovided)
FlatBladeScrewdriver
PhillipsHeadScrewdriver
Mallet
1xAllen key
(provided)
(H1) (H4)
1 x Allen key
12 x
Allen Bolts
(H2) (H3)
12 x Washers 12 x Washers
(p 2 )
(p 1 )
(p 2 )
(p 2 )
(p 2 )
(p 3 )

Page 4
Step 1
You Will need:You Will need:
(H1)
2 x
Allen Bolts
(H4)
1 x Allen key
(H2)
2 x
Washers
(H3)
2 x
Washers
Step 2
You Will need:You Will need:
(H1)
4 x
Allen Bolts
(H4)
1 x Allen key H1
H3
H2 H4
(p 3 )
(p 2 )
(p 2 )
(p 2 )
(p 2 )
(H2)
2 x
Washers
(H3)
2 x
Washers
H1 H3 H2
H4

Page 5
Step 3
Step 4
You Will need:You Will need:
(H1)
8 x
Allen Bolts
(H4)
1 x Allen key
(H2)
8 x
Washers
(H3)
8 x
Washers
H1 H3 H2
H4

Page 6
The job is complete!
Intheinterestofourenvironment
Pleasedisposeofallpackagingthoughfully
Step 5