Jaypro Sports PVB SERIES User manual

JSL-Inst046
www.jayprosports.com
JAYPRO PVB SERIES SECOND FLOOR INTERNATIONAL NET SYSTEM
Installation and Operating Instructions
Applicable Part Numbers/Models:
PVB-2500: Second Floor International Net System

PVB Series Second Floor International Net System Instructions
- 1 of 11-
JSL-Inst046
www.jayprosports.com
Table of Contents
1Safety................................................................................................................ 1
2Specifications.................................................................................................. 1
3Introduction ..................................................................................................... 2
4Required Tools................................................................................................. 4
5Included Hardware & Components............................................................ 4
5.1 System Components.............................................................................. 4
5.2 Hardware................................................................................................. 6
6Assembly .......................................................................................................... 7
7Maintenance ................................................................................................ 11
1Safety
WARNING: Do not attempt to remove the height adjuster pin if the net is under
tension.
WARNING: Always use protective padding around each upright during use.
WARNING: Uprights are heavy. Do not attempt to lift or install without assistance.
IMPORTANT: Follow all warning labels on equipment.
IMPORTANT: Inspect for damage before and after each use.
IMPORTANT: Do not use unless installed into floor anchors.
2Specifications
UPRIGHT
OUTER
DIAMETER
HEIGHT RANGE
#OF
POSITIONS
WEIGHT
UPPER
UPRIGHT
MATERIAL
LOWER
UPRIGHT
MATERIAL
PVB-2500
3-1/2”
(89mm)
6’6” to 8’2”
(1.8m to 2.5m)
16
Pin Stops
145 lbs
(66kg)
Aluminum
6063
Aluminum
6063

PVB Series Second Floor International Net System Instructions
- 2 of 11-
JSL-Inst046
www.jayprosports.com
3Introduction
Note: The Flex Net supplied with this system will stretch slightly during the first few uses.
This is a natural consequence of the headband fibers being stretched under tension.
During this break-in period, the headband and net body may sag during use. Simply
increase tension to remove the sag.
These instructions assume that the appropriate floor anchors have been correctly
installed:
The anchors must be internally threaded with 1/2'”-13 threads
The anchors must be installed 17” apart on center (see Figure 3-1).
The Flex-Net will work with upright standards spaced 35’ to 37’ apart on center
1
.
Please consult the instructions and specifications supplied with your floor anchors for
more information.
If you require additional information or support to install or operate your volleyball system,
please contact the Jaypro Sports customer support team, Monday through Friday,
8:30AM to 5:00 PM (EST), at 1-800-243-0533.
1
NCAA and NFHS rules require that the upright standards must be installed at least 3’3”
(1m) outside the court boundaries. Jaypro recommends 36’ spacing on center to satisfy
both regulations.

PVB Series Second Floor International Net System Instructions
- 3 of 11-
JSL-Inst046
www.jayprosports.com
Figure 3-1: Correct floor anchor layout.
Refer to instructions included with floor anchors for anchor installation details.

PVB Series Second Floor International Net System Instructions
- 4 of 11-
JSL-Inst046
www.jayprosports.com
4Required Tools
Before continuing, please verify that you have the following tools required to complete
the installation and setup of your PVB Series Collegiate Net System.
Adjustable wrench
Hex keys –3/16”, 5/16”
5Included Hardware & Components
Before continuing, please open all packages to verify that you have all the required
hardware for installation and setup. If any of the following items are missing, contact the
Jaypro Sports customer support team, Monday through Friday, 8:30AM to 5:00 PM (EST),
at 1-800-243-0533.
5.1 System Components
Figure 5-1: PVB-2500 Standard Upright (PVB250B, 2X)
Figure 5-2: T-Base (PVB-35TB, 2X)

PVB Series Second Floor International Net System Instructions
- 5 of 11-
JSL-Inst046
www.jayprosports.com
Figure 5-3: Winch with strap (PVBWINCH, 1X).
Figure 5-4: Flex-Net (PVBN-6, 1X)
Figure 5-5: Antennae and Net Tapes (VBA-4, 1 pair)

PVB Series Second Floor International Net System Instructions
- 6 of 11-
JSL-Inst046
www.jayprosports.com
Figure 5-6: Anchor Strap (PVB-604, 1X)
5.2 Hardware
Figure 5-7: Socket Cap Screw (HS5098, 1X)
Figure 5-8: Button-Head Cap Screw (HS5201, 1X)
Figure 5-9: Acorn Nut (HN809, 2X)
Figure 5-10: Spacer Bearing (HM6347, 1X)

PVB Series Second Floor International Net System Instructions
- 7 of 11-
JSL-Inst046
www.jayprosports.com
6Assembly
WARNING: Uprights are heavy. Do not attempt to lift or install without assistance.
1. Install each upright into the t-bases and tighten each square headed set screw.
2. Follow instructions included with winch to set the winch clamp to the correct
upright diameter (3-1/2”).
3. Install winch to one upright using the socket cap screws (Figure 6-1, item 2).
4. Fasten the clamp together using the cap screws supplied with the winch (Figure
6-1, item 4-1).
Figure 6-1: Winch installation.

PVB Series Second Floor International Net System Instructions
- 8 of 11-
JSL-Inst046
www.jayprosports.com
5. Install the anchor strap to the upright without the winch (Figure 6-2).
Figure 6-2: Install anchor strap.
6. Roll the standards into position with the hand knob assemblies directly over the
floor anchors.
7. Thread the hand knob into the anchor; be sure to get at least ¾” of thread
engagement (Figure 6-3). Tighten locking handle to lock and knob in place.
Figure 6-3: Installing t-base into floor anchors.

PVB Series Second Floor International Net System Instructions
- 9 of 11-
JSL-Inst046
www.jayprosports.com
8. Set the height of the uprights using the installed height adjust pin (Figure 6-4).
WARNING: Do not attempt to remove the height adjuster pin if the net is under tension.
Figure 6-4: Set upright height.
9. Attach one end of net to anchor strap, then attach other end to winch strap
(Figure 6-5).
Figure 6-5: Attach net to straps.
10. Adjust the length of the anchor strap as necessary to center net on court.
***The net will stretch ~6 –8 inches when tension is applied so you must factor this
in before applying tension when centering the net.
11. Tension the net by turning the winch handle clockwise
2
.Adjust anchor strap as
necessary to keep net centered.
2
NCAA and NFHS rules stipulate that there be no more than ¾” of sag in the net
headband when fully tensioned.

PVB Series Second Floor International Net System Instructions
- 10 of 11-
JSL-Inst046
www.jayprosports.com
12. Verify net heights and net centering. The uprights will deflect inward and
downward due to net tension; you may need to adjust their heights and/or re-
center the net.
13. Attach the bottom net straps to each upright as shown in Figure 6-6. Wrap Velcro
straps around buckles for additional player safety.
Figure 6-6: Secure bottom net straps to uprights.
14. Attach net antennae and tapes according to instructions included with
antennae set.
15. Install pads (PVB-60P) around each upright and base pad (PVB-25P).
PVB-25P
PVB-60P

PVB Series Second Floor International Net System Instructions
- 11 of 11-
JSL-Inst046
www.jayprosports.com
7Maintenance
Your PVB Series Second Floor International Net System is designed to provide years of
play; however, it is recommended that the components be inspected at least once
every season, for signs of excessive wear. Key areas to inspect include (but are not
limited to):
Strap webbing
Net
Spring clips and D-rings
Winch mechanism
Screws and nuts
If you require additional information or support maintaining your volleyball system, please
contact the Jaypro Sports customer support team, Monday through Friday, 8:30AM to
5:00 PM (EST), at 1-800-243-0533.