Jaypro Sports PB-15PI User manual

JAYPRO SPORTS
15’ PERMANENT PLAYER’S BENCH, PB-15PI
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 AR5043 SEAT PLANK 1
2 75PI1 BENCH LEG PERMANENT 3
3 HN5046 5/16” FLANGE NUT 9
4 EP0018 2” x 2” END PLUG 6
5 HB5030 5/16”-18 x 3” CARRIAGE BOLT 9
6 AR5044 HOLD DOWN CLIP 6
7 AR5045 END CAP 2
8 HS5035 #8 PAN HEAD SCREW x ½” 4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: PHILLIPS SCREWDRIVER BIT WITH ELECTRIC DRILL (1),
½” SOCKET WRENCH OR ADJUSTABLE WRENCH
1) Slip the end caps (7) snugly onto each end of the plank (1). Using the electric
drill, assemble a self-drilling screw (8) through the cap and into the flange of the
plank. Two screws are required per end cap.
2) For easiest assembly, position seat plank (1) on a level raised surface such as a
desk top, bleacher seat or work bench. Place the carriage bolt (5) and bolt clips
(6) approximately into place within the slots of the plank. Note that the legs
should be no more than 8” from the plank edge. Also assemble a bolt (5) and nut
(3) through the lowest hole of the leg extension to help lock the leg in the footing.
3) Position the legs as shown and loosely assemble the hardware illustrated in
‘Detail A-A’. Do not fully tighten the hardware at this time.
4) Stand the unit upright level the bench and make sure the legs are adequately
spaced apart. Tighten all fasteners fully.
5) Locate your bench and dig footings to the dimensions shown on the illustration.
Mark each leg at 18” from bottom of leg.
6) Fill in footings with concrete, then, lower assembled bench into the footings.
Block up under bench to support the bench at the mark on each leg. Level seat
plank and adjust bench as necessary.
7) Allow footings to cure at least 72 hours before removing the supports or using the
bench.