Jaypro Sports PCG-800 User manual

REV - A Page 1 of 7
--- PCG-800 ---
(PORTABLE PRACTICE
FOOTBALL / SOCCER GOAL)
Installation Instructions
Call Jaypro Sports Equipment at 1-800-243-0533
during regular business hours for technical support.
www.jaypro.com

REV - A Page 2 of 7
JAYPRO SPORTS
PORTABLE PRACTICE FOOTBALL / SOCCER COMBO GOAL
IMPORTANT NOTICE:
1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING
HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.
2) NEVER ALLOW ANYONE TO CLIMB OR HANG ON THE NET OR GOAL
FRAME. AS SERIOUS INJURY OR DAMAGE TO THE EQUIPMENT MAY
OCCUR.
3) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE
HAZARDOUS.
4) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE
HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.
TOOLS REQUIRED:
(1) Socket and / or Box Wrench Set
(1) Electric Drill with 1/4” Socket Bit or Driver
(1) Step Ladder, 12 FT
(1) Rubber Mallet
•Unpack all parts and check against parts list to ensure that all have been included.
•Inspect all parts for damage. Report any damages to the trucking company.
ITEM
DESCRIPTION
PCG-800
1
CROSSBAR x 288” LONG
2
2
BENT FRONT UPRIGHT
2
3
WHEEL WELDMENT
2
4
FOOTBALL CROSSBAR x 280” LONG
1
5
BASE BACKSTAY x 120” LONG
2
6
BACKSTAY
2
7
2” PIPE CLAMP
20
8
1/2”-13 STOVER LOCK NUT
28
9
1/2” SAE FLAT WASHER, ZP
28
10
1/2”-13 x 3” HEX HEAD CAP SCREW, ZP
28
11
2” LIGHT CAP
2
12
2” PLASTIC PLUG
2
13
10” NO FLAT WHEEL
4
14
5/8” SAE FLAT WASHER, ZP
12
15
5/8”-11 LOCK NUT, ZP
2
16
5/8”-11 x 9-1/2” HEX HEAD CAP SCREW, ZP
2
17
5/8" I.D. x 3/4" O.D. x 5/8" LONG BEARING, BRNZ
4
18
#8 x 3/4" HEX HEAD FLANGE SELF DRILL SCREW, ZP
4
19
SOCCER NET (OPTIONAL IF PURCHASE)
1
20
3/4" WIDE WHITE ONE WRAP x 4 YD (IF PURCHASE)
1
21
WIND STREAMERS (OPTIONAL IF PURCHASE)
2
QTY

REV - A Page 3 of 7
Overall View

REV - A Page 4 of 7
Assemble front upright frame:
Assemble wheel:

REV - A Page 5 of 7
Assemble backstay:

REV - A Page 6 of 7
Assemble rear frame:

REV - A Page 7 of 7
Assemble crossbars:
Install soccer net: (Net sold separately)
1. Install the rear backstays into place with each pipe clamp as shown.
2. Locate the upper corner of the net. Draping the net over both backstays. Cut the
3/4" wide white one wrap x 4 yard into 9” lengths. Then warp the 9” lengths of
Velcro net tie along the crossbar. Secure the front edge of the net to the pipe using
9” lengths of Velcro net tie.