Jaypro Sports RGB-3 User manual

Installation Manual
Call Jaypro Sports at 1-800-243-0533 during
regular business hours for technical support.
www.jayprosports.com
RGB-3
OFFICIAL RUGBY GOAL

DESCRIPTIONPART #QTY
ITEM
OFFICIAL RUGBY CROSSBARRGP-305
11
3/8-16 x 4-1/2 HEX CAP SCREW-ZP-GrNCHS294
42
3/8 SAE WASHER-ZP-GrNC
HW2047283
3/8-16 UNC-Thin Nylon Lock Nut-ZP-GrNC
HN123014
4
OFFICIAL RUGBY TOP INSERTRGP-302
2
5
RUGBY GOAL CLAMPRGP-3-X
46
RUGBY UPRIGHTRGP-304
2
7
3/8-16 x 5 HEX CAP SCREW-ZP-GrNCHS5078
108
GROUND SLEEVE PAIR (OPTIONAL)FBSLV4
19
FLAG WIND STREAMER PAIR (OPTIONAL)WS-42
110
RGB-3 - INSTALLATION MANUAL
www.jayprosports.com / [phone] / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
©COPYRIGHT 2023 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 2 of 5
NOTE: HARDWARE,
OPTIONAL GROUND
SLEEVES, AND
OPTIONAL
STREAMERS NOT
DEPICTED
IMPORTANT NOTICE:
1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER
CONNECTING HARDWARE AND STRUCTURAL INTEGRITY.
REPLACE DAMAGED OR MISSING HARDWARE IMMEDIATELY.
2) NEVER ALLOW ANYONE TO CLIMB OR HANG ON THE NET OR
GOAL FRAME. AS SERIOUS INJURY OR DAMAGE TO THE
EQUIPMENT MAY OCCUR.
3) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE
HAZARDOUS.
4) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE
HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.
NOTE:
A. Unpack all parts and check against parts list to ensure that all have been
included.
B. Inspect all parts for damage. Report any damages to the trucking company.
7
1
56

RGB-3 - INSTALLATION MANUAL
www.jayprosports.com / [phone] / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
©COPYRIGHT 2023 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 3 of 5
I. Locate and Excavate Footings: (IF INSTALLING GROUND SLEEVES REFER TO SLEEVE
INSTRUCTIONS FBSLV4)
NOTE: FOR BEST RESULTS, THIS UNIT SHOULD BE INSTALLED BY A LOCAL
CONTRACTOR WHO IS FAMILIAR WITH LOCAL CONDITIONS AND BUILDING
CODES.
1) The footings as shown represent minimum requirements. Check local building codes before
starting the footing. Local building codes should be adhered to if requirements are greater than
those outlined here.
2) Locate the position of the rugby goal on the field. Layout and excavate the footings as
shown below.
IMPORTANT:
If installing the goalpost into pre-set sleeves, verify the spacing between sleeves is 18'-8 ½”
center to center. To help insert the uprights into the sleeves, liberally apply some lithium or
teflon grease to the bottom of the uprights.
18'-8 1/2"
CENTER TO CENTER
PLAYING SURFACE
54 in
6 in
48 in
36 inØ
CRUSH STONE OR
CONCRETE BLOCK
SOIL

A
RGB-3 - INSTALLATION MANUAL
www.jayprosports.com / [phone] / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
©COPYRIGHT 2023 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 4 of 5
II. Assemble and Install Lower Frame:
1) Assemble the lower H-Frame on the ground as shown.
2) Using appropriate handling equipment, lift and place the H-Frame into the footings.
3) After plumbing the uprights and leveling the crossbar, securely brace the H-Frame, primarily in the
front and back direction.
4) Pour the concrete, using a minimum 4,000 psi mix.
5) Allow concrete to cure for 48 hours, before installing the top upright.
NOTE: INSTALL CORNER CLAMPS
ONTO UPRIGHTS FIRST BUT DO
NOT FULLY TIGHTEN HARDWARE
UNTIL CROSSBAR IS INSERTED.
PLAYING SURFACE
0'-2" BELOW
PLAYING SURFACE
3/4" REBAR
(SUPPLIED BY
INSTALLER)
6 PLACES
36 inØ
48 in
6 in
54 in
18'-4 1/2"
9'-10"
20'
8
3
1
7
7
n7/16 inREF
REF Ø7/16 in
6
6
1
4
3
6
7

DETAIL B
B
RGB-3 - INSTALLATION MANUAL
www.jayprosports.com / [phone] / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
©COPYRIGHT 2023 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 5 of 5
III. Install Top Upright:
Note: DO NOT INSTALL UNTIL CONCRETE IS FULLY CURED
1) If purchased, install the flag kit. Refer to WS-42 instructions.
1) Insert the top upright into one of the lower uprights. Plumb the upright and drill a 25/64”hole to
install the top bolt. Recheck the plumb and drill and install the bottom bolt.
20'
9'-10"
18'-4 1/2"
32'
5
4
3
3
2
5
5
7
77