Jaypro Sports PB-5SM User manual

JAYPRO SPORTS
21’ PLAYER’S BENCH, PB-5SM
LIST OF MATERIALS
PIECE # PART # DESCRIPTION QTY.
1 AR5052 SEAT PLANK 21’ 1
2 PB751SM BENCH LEG 4
3 HN5046 5/16” FLANGE NUT 8
4 EP0018 2” x 2” END CAP 8
5 HB5030 5/16”-18 x 3” CARRIAGE BOLT 8
6 AR5044 HOLD DOWN CLIP 8
7 AR5045 END CAP 2
8 HS5035 #8 PAN HEAD SCREW x ½” 4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: PHILLIPS SCREWDRIVER BIT W/ ELECTRIC DRILL (1),
½” SOCKET WRENCH OR ADJUSTABLE WRENCH (1)
1) Slip the end caps (7) snugly onto each end of the plank (1). Using the electric
drill, assemble a self-drilling screw (8) through the cap and into the flange of
the plank. Two screws are required per end cap.
2) For easiest assembly, position seat plank (1) on a level raised surface such
as a desk top, bleacher seat or work bench. Place the carriage bolt (5) and
bolt clips (6) approximately into place within the slots of the plank. Note that
the legs should be no more than 8” from the plank edge.
3) Position the legs as shown and loosely assemble the hardware illustrated in
detail ‘a-a’. Do not fully tighten the hardware at this time. Level the bench
and make sure the legs are adequately spaced apart. Tighten all fasteners
fully.
4) Locate assembled bench into position and carefully mark the hole locations
for each mounting plate. Use fasteners (minimum 3/8” diameter) appropriate
for your surface material. Follow manufacturer’s instructions fully.