Jaypro Sports PB-90PI User manual

Jaypro Sports
976 Hartford Turnpike
Waterford, CT 06385 USA
[phone]
www.jaypro.com
[phone] Fax
MODEL NO.:
PRODUCT NAME:
EFFECTIVE DATE:
DRAWN BY: MT 1/25/2011
DETAIL A-A
3
1
6
4
2
7
8" TYP
EACH END
2
SEE
DETAIL A-A
6
18"
SQ.
6"
18"
3
AVERAGE SOIL CONDITIONS.
SUGGESTED DIMENSIONS FOR
NOTE: THESE ARE MINIMUM
8
PB-90PI
27' PLAYERS BENCH WITH BACK REST
76 1/2" TYP
CTR TO CTR

REV- 2/2/2011
JAYPRO SPORTS
27’ PERMANENT PLAYER’S BENCH WITH BACK REST, PB-90PI
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 AR5044 Bolt Clip With Slot 20
2 AR5045A End Cap 4
3 HB5030 Carriage Bolt 5/16”-18 X 3” 25
4 HS5035 #8 Pan Head Screw x ½” 8
5 EP0018 2” X 2” End Plug 20
6 HN5046 Flange Nut 5/16” 25
7 AR5111 Seat Plank x 27’2
8 PBR-L Leg 5
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Screwdriver Bit With Electric Drill (1),
½” Socket Wrench or Adjustable Wrench (1)
1) Slip the end caps (2) snugly onto each end of each plank (7). Using the electric
drill, assemble a self-drilling screw (4) through the cap and into the flange of the
plank. Two screws are required per end cap.
2) For easiest assembly, position seat plank (7) on a level raised surface such as a
desk top, bleacher seat or work bench. Place the carriage bolt (3) and bolt clips
(1) approximately into place within the slots of the plank. Note that the outside
legs should be no more than 8” from the plank edge. Also assemble a bolt (3) and
a nut (6) through the lowest hole of the leg extension to help lock the leg in the
footing.
3) Position the legs (8) as shown and loosely assemble the hardware illustrated in
detail ‘A-A’. Do not fully tighten the hardware at this time.
4) Stand the unit upright and assemble the backrest plank (7) as illustrated. Level
the bench and make sure the legs are adequately spaced apart. Tighten all
fasteners fully.
5) Locate your bench and dig footings to the dimensions shown on the illustration.
Mark each leg at 18” from bottom of leg.
6) Fill in footings with concrete, then, lower assembled bench into the footings.
Block up under bench to support the bench at the mark on each leg. Level seat
plank and adjust bench as necessary.
7) Allow footings to cure at least 72 hours before removing the supports or using the
bench.