Jaypro Sports PVB-5500 User manual

Page 1of 7
-- PVB-5500 --
Installation Instructions
Call Jaypro Sports Equipment at 1-800-243-0533
during regular business hours for technical support.
www.jaypro.com

Page 2of 7
PVB-5500
PARTS LIST (QTY: SINGLE UNIT)
ITEM
IMAGE
DESCRIPTION
QTY
1
STANDARD UPRIGHTS
P/N: PVB-55U
2
2
VOLLEYBALL WINCH
P/N: PVBWINCH
1
3
VOLLEYBALL FLEX NET
P/N: PVBN-6
1
4
VOLLEYBALL ANTENNA
P/N: VBA-4
1
5
ANCHOR STRAP
P/N: PVB-604
1
6
WINCH HARDWARE KIT:
3/8”-16 x 4 1/4" BUTTON HEX SCREW
3/8” ACORN NUT
PART OF PVBWINCH HARDWARE KIT
1 ea
7
3/8”-16 x 3 1/2" BUTTON HEX SCREW
P/N: HS5201
1
8
3/8” ACORN NUT
P/N: HN809
1
9
3/8” SPACER
P/N: HM6347
1
ITEM
IMAGE
DESCRIPTION
QTY

Page 3of 7
Table of Contents
IMPORTANT NOTICE:
1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING
HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.
2) NEVER ALLOW ANYONE TO CLIMB OR HANG ON THE NET OR GOAL
FRAME. AS SERIOUS INJURY OR DAMAGE TO THE EQUIPMENT MAY
OCCUR.
3) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE
HAZARDOUS.
4) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE
HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.
5) DO NOT ATTEMPT TO REMOVE THE HEIGHT ADJUSTER PIN IF
THE NET IS UNDER TENSION.
6) ALWAYS USE PROTECTIVE PADDING AROUND EACH UPRIGHT
DURING USE.
7) UPRIGHTS ARE HEAVY. DO NOT ATTEMPT TO LIFT OR INSTALL
WITHOUT ASSISTANCE.
Tools Require:
1
Adjustable Wench
1
3/16” & 5/16” Hex Keys
1
Tape Measure
oUnpack all parts and check against parts list to ensure that all have been
included.
oInspect all parts for damage. Report any damages to the trucking
company.
These instructions assume that the appropriate ground sleeves have been correctly
installed:
• The PVB-5500 will fit most 2’’ inner diameter ground sleeves.
• The inside bottom surface of the ground sleeves must be at least 8” below floor level.
Please consult the instructions and specifications supplied with your ground sleeves for
more information.
If you require additional information or support to install or operate your volleyball
system, please contact the Jaypro Sports customer support team, Monday through Friday,
8:30AM to 5:00 PM (EST), at 1-800-243-0533.

Page 4of 7
Upright Assembly:
WARNING: Uprights are heavy. Do not attempt to lift or install without assistance.
1. Install each upright into the ground sleeves.
2. Follow instructions included with winch to set the winch clamp to the correct
upright diameter (3-1/2”).
3. Install winch to one upright using the button head cap screw and acorn nut (Item
1, 2 & 4-1 included with PVBWINCH).
4. Fasten the clamp together using the cap screws supplied with the winch.
N/A
N/A
PVB-55U
3/8” ACORN NUT
3/8”-16 x 4 1/4" BUTTON HEX SCREW
STANDARD UPRIGHTS

Page 5of 7
5. Install the anchor strap to the upright without the winch (Figure 6 2).
6. Set the height of the uprights using the installed height adjust pin (Figure 6 3).
WARNING: Do not attempt to remove the height adjuster pin if the net is under tension.
HN809
PVB-55U
HS5201
PVB-604
HM6347
3/8” ACORN NUT
STANDARD UPRIGHTS
3/8”-16 x 3 1/2" BUTTON HEX SCREW
ANCHOR STRAP
3/8” SPACER

Page 6of 7
7. Attach one end of net to anchor strap, then attach other end to winch strap
(Figure 6 4).
8. Adjust the length of the anchor strap as necessary to center net on court.
***The net will stretch ~6 –8 inches when tension is applied so you must
factor this in before applying tension when centering the net.
9. Tension the net by turning the winch handle clockwise .Adjust anchor strap as
necessary to keep net centered.
10. Verify net heights and net centering. The uprights will deflect inward and
downward due to net tension; you may need to adjust their heights and/or re-
center the net. WARNING: Release tension from the net before removing
height adjust pin.
11. Attach the bottom net straps to each upright as shown in Figure 6 5. Wrap Velcro
straps around buckles for additional player safety.
12. Attach net antennae and tapes according to instructions included with antennae set.
13. Install pads around each upright.
PVB-55U
STANDARD UPRIGHTS
PVB-55U
STANDARD UPRIGHTS

Page 7of 7
Maintenance:
Your PVB Series Collegiate Net System is designed to provide years of play; however, it is recommended
that the components be inspected at least once every season, for signs of excessive wear. Key areas to
inspect include (but are not limited to):
▪Strap webbing
▪Net
▪Spring clips and D-rings
▪Winch mechanism
▪Screws and nuts
If you require additional information or support maintaining your volleyball system, please contact the
Jaypro Sports customer support team, Monday through Friday, 8:30AM to 5:00 PM (EST), at 1-800-243-
0533.
NCAA and NFHS rules require that the upright standards must be installed at least 3’3”
(1m) outside the court boundaries. Jaypro recommends 36’ spacing on center to satisfy
both regulations.