Jaypro Sports PVBN-5 Instruction sheet

A
PVBN-5_INSTALL
www.jayprosports.com / [phone] / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
©COPYRIGHT 2022 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 1 of 2
1. SET POSTS TO
DESIRED HEIGHT.
2. LENGTHEN WINCH
STRAP. IT SHOULD SIT AT
OR BELOW THE WINCH
BEFORE MOVING
FORWARD.
3. SHORTEN LENGTH OF
ANCHOR STRAP AS MUCH
AS POSSIBLE BEFORE
BUCKLE REACHES
PULLEY.
4. CONNECT PRE-MADE LOOP ON TOP CABLE
TO ANCHOR END.
DETAIL A
5. WALK NET ACROSS THE COURT AND BRING OTHER END CLOSE TO WINCH POST.
6. TIE KNOT AT END AS SHOWN TO CREATE A LOOP AND SHORTEN THE TOP CABLE AS MUCH AS POSSIBLE. DO NOT CUT EXCESS ROPE UNTIL SET UP IS COMPLETE.
7. CONNECT THE KNOTTED LOOP TO THE STRAP ON THE WINCH POST.
A SECOND PERSON LIFTING THE
NET TO REDUCE SLACK AND
KEEP NET OFF GROUND WILL HELP

PVBN-5_INSTALL
www.jayprosports.com / [phone] / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
©COPYRIGHT 2022 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 2 of 2
11. TIE ONE END OF
BOTTOM CABLE TO A
POST LEAVING LITTLE
TO NO EXTRA LENGTH.
FOR EASY
BREAKDOWN/SETUP,
TIE LOOP IN CHORD AS
SEEN BELOW FOR
CABLE WINCH, BUT
WRAPPING REMAINING
CABLE AROUND POST
AND ATTACHING TO
LOOP WITH SNAP
HOOK RATHER THAN
CABLE WINCH.
12. CREATE A LOOP ON
THE OTHER END OF
THE BOTTOM CABLE
AS CLOSE TO THE NET
AS POSSIBLE AS DONE
PREVIOUSLY ON THE
TOP CABLE. LEAVE AS
MUCH EXCESS
LENGTH AS POSSIBLE.
12. CONNECT
LOOP TO SNAP
HOOK.
13. SEND EXCESS
ROPE AROUND
POST AND THEN
PULL THROUGH
CABLE WINCH TO
TIGHTEN.
NOTE: CABLE
WINCH SHOWN
(P/N HM6638) NOT
INCLUDED WITH
NET - TO BE
INCLUDED WITH
SYSTEM
HARDWARE.
14. INSERT WHITE STRAPS
THROUGH OBLONG CUTOUTS
AND AROUND UPRIGHT. USE
THREE PER POST.
15. PULL TO DESIRED
TENSION AND SECURE USING
VELCRO.
PULLTOTIGHTEN
INWINCH
TO NET
10. ONCE NET IS PROPERLY CENTERED AND
TENSIONED, THE EXCESS ROPE MAY BE CUT FROM
THE TOP ROPE. WE RECOMMEND LEAVING ~2FT IN
CASE FURTHER ADJUSTMENT IS NEEDED IN THE FUTURE
TIGHTEN
LENGTHEN
8. CRANK WINCH UNTIL DESIRED TENSION AND NET HEIGHT IS REACHED. IF UNABLE TO REACH
DESIRED TENSION BECAUSE BUCKLE ON WINCH STRAP REACHES PULLY, SLIDE NET TO ANCHOR POST
AND GO BACK TO STEP 2. LENGTHEN WINCH STRAP MORE AND SHORTEN TOP CABLE BY MOVING KNOT.
9. CENTER NET BY SLIDING IT ON TOP CABLE. IF UNABLE TO MOVE NET TOWARDS WINCH SIDE AS
NEEDED, LENGTHEN ANCHOR STRAP AND TIGHTEN WINCH ACCORDINGLY.