JDiag Super EL50448 User manual

GF
Super EL50448
User Manual
FasTPMS Super EL50448
JDiag ElectronicsTechnologyCo.,Ltd.

GF
Super EL50448
9V Battery
Antenna
Power Button
Yellow Indicator light
Ford Vehicles
Green Indicator light
GM Vehicles
Screw
JDiag FasTPMS Super EL50448 is new product
develpoed byJDiag Eletronics Technology Co.,Ltd
in 2017, whichis able to work withboth GM
series and Ford seriesTPMS relearn tool, Super
EL50448 is essential toolofreplacement tire
pressure sensor, tire pressure alarmremove or
exchange tires for GM series( Chevy / Buick /
GMC )Ford series ( Lincoln /Mercury), etc.

GM series cars:
1. Make the gear in P position.
2. Use cruise to choose TPMS re-learn mode in
the dashboard settings.
3. Horn will ring twice and the TPMSindicator
flashes, then the learning mode has been
successfully entered. If equipped, the message
center will display the front left (LF) tire
Ford series cars:
1. Make the gear in P position.
2. With the ignition switchto OFF, press and
release the brake pedal
3. Turn the ignition switch from the OFF position
to theRUN position 3 times and end at RUN
position
How to switch between GM and Ford
brand?
Hold the power button for 3 seconds then 2 LEDs
flashing 2 times, selected brand’s LED flashing 2
times.
How to detetied which mode the device
in?
Press the power button,if the Green LED flashing,
means Super EL50448 in GM mode,if the Yellow
LED flashing, means Super EL50448 in Ford
mode.
How to use Super EL50448?
1. Need 1x pcs 9v battery to work
2. Set the car in TPMS learningmode. (car horns)
3. Starting fromthe left front tire, the antenna of
the dedicated tool for tire pressure monitoring is
facing upwards against the tire sidewall near the
rim of the valve stemto start the antenna. Press
and release the button and wait for the speaker
to emit a chirp. Once the speaker is chirping, the
sensor information is read and the turn signal to
be read at the next position will light.
4. Follow this order to rest TPMS one by one:
front left, frontright,rear right, rear left.
5. After all sensors reseted, the car horns, the
TPMS re-learn finished.
How to set my car in TPMS re-learn
mode?

4. Depressand release the brake pedal
5. Ignition to OFF position
6. Ignition goes from the OFF position to the RUN
position 3 times and ends atRUN position
7. Horn will ringonce and the TPMSindicator
flashes, then the learningmode hasbeen
successfully entered. If equipped,the message
center will display the front left (LF) tire
Operation Instruction:
Notice:
1. When using Super EL50448, please make sure
antenna fit in correctposition.
2. Please make sure the 9v battery in good
condition.
Manufacture:JDiag Electronics Technology Co.,Ltd.
Address:5th floor,building 1,Binxianghua IndustrialPark,7
Huada str,Longhua District,Shenzhen,Guangdong,P.R.
China.
Tel: [phone]
Fax: [phone]
Website: http://www.jdiag.com