TEKTELIC Communications TUNDRA User manual

TEKTELIC TUNDRA Sensor
Quick Start Guide

The device is shipped with the batteries installed and in a state of DEEP-SLEEP until activated with a magnet.
There is no need to open the enclosure to activate the device.
To activate the device, move the provided magnet close to the magnet symbol at the bottom of the enclosure
using a specific switch pattern:
Note:
•This magnetic pattern always triggers a module reset, even during normal operation.
•LED will blink for every message sent to Network Server.
Magnet Switch
LED
Activating the Device
Magnet Symbol
Magnetic Pattern to Activate or Reset Device
Step 1: Bring Magnet within 2cm of Magnet Switch on
device (see picture) for 5 seconds
Step 2: Remove Magnet away from Device. LED will blink
until device has joined Network Server.

The default data reporting periods are listed in Table 1. To make changes to the default data
reporting periods, please refer to the knowledge base on the support portal at
support.tektelic.com
Table 1: Default Reporting Periods of the TUNDRA Sensor
Activation & Configuration
Commissioning the Device Using LeapX Application
To use LeapX, you will need a TEKTELIC Account. If you don’t have an account already, please
raise a ticket in our support portal support.tektelic.com and our support team will create an
account for you. To install LeapX Application on your Smart Device, please search for
“TEKTELIC LeapX” on the Google Play Store or the Apple App Store. Once the app is installed,
log in to the app using the username and password of your TEKTELIC account. Then follow
the in-app instructions online.

Note:
If you have questions about using this device please visit the TEKTELIC Support Portal
support.tektelic.com for access to our knowledge base.
www.tektelic.com
Troubleshooting
If the device remains blinking green for more than two minutes follow these
troubleshooting actions:
•Ensure the device is commissioned on the Network Server
•Ensure the local LoRa Gateway has also been provisioned on the Network Server
•Ensure a local LoRa Gateway is online
Note: The first time a sensor is woken up or powered on with a new battery, there
may be up to two minutes of additional ramp up time before the sensor joins the
network server
•See Section 1.3 of the Technical Resource Manual (TRM) for more details