Jilong 1282859 User manual

Keep a working phone and list of emergency numbers near the pool.
Become certified in cardiopulmonary resuscitation (CPR) so you can respond to an emergency
Pools present a drowning hazard even during filling and draining. Maintain constant supervision of
children until the pool is completely empty and stowed away.
ELECTROCUTION RISK:
Keep all electrical lines, radios, speakers and other electrical devices away from the pool.
Do not place the pool near or under overhead electrical lines.
ASSEMBLY:
1. Inflating and filling the pool takes around 1 hour.
2. Select flat ground and make sure there are no stones, gravel, glass and any other sharp-edged
objects in the area. Never install the pool on a hard surface such as concrete or asphalt. Never
install the pool close totrees (falling leaves) and any source of electric power. Do not install the
pool on a slope or inclined surface, on soft or loose soil conditions (such as sand or mud) or on an
elevated surface such as a deck, platform or balcony, which may collapse under the weight of the
filled pool.
3.Locate the pool as close as possible to a drain area, because it will be impossible to move the
pool once it is full of water.
4.Remove the product from the packaging and check to ensure you have all the parts. For any
missing parts please contact our Customer Service Department toll free at: 1-866-946-3002
Monday toFriday 9am – 4pm PST or by email at [e-mail]
5.Unfold the pool on the ground and lay flat.
6. Inspect for holes and tears.
7.Locate and open the inflation valve.
8. It is recommended that you use only a hand or foot pump for inflation. Caution: Do not use
high-pressure air to inflate. Do not over-inflate.
9. Once the top ring is inflated, fill with water tothe warning line marked on the inside wall of the
pool. Do not fill the pool to more than 80% of the maximum volume.
POOL CARE
CLEANING INSTRUCTIONS:
Remove all leaves and other debris from the pool daily. Replace the water on a regular basis
especially if the water is cloudy. If the sides of the pool are dirty or slimy empty the pool and then
scrub them with a brush or sponge using soap and hose down. Do not use any chemicals or
cleaning fluids to clean the PVC as they can damage it.
POOL MAINTENANCE：
Check the pool at regular intervals for holes, tears or other damage. Do not use a damaged pool –
it could result in serious injury or death.
REPAIR PATCH INSTRUCTIONS：
In the event of an accidental puncture, cut out a suitable sized patch. Round the corners of the
repair patchto avoid peeling. Make sure the area to be patched is clean and dry. Press patch
firmly over the puncture. Do not inflate for 30 minutes. Do not use the patch for holes or rips on
the seam.
AFTER USE：
Open the drain valve. Carefully lift the pool sidewall from the base and slowly tip to drain away
water. Open the valve covers and deflate the product. Brush away any dirt and debris. Clean the
pool with soap and rinse with water. Air dry. The pool must be completely dry before storing or it
will encourage mold and may damage the liner.
Store in a secure location between 5°C and 37°C away from children to prevent suffocation.
2

Made in China
JILONG PLASTIC PRODUCTS (JIANGSU) CO., LTD., NO.1 Industrial Area South Zhongchen
Road Zhongyang Town, Suqian, Jiangsu, China. jilong.com
Distributed in North America by Fun-Zone Inflatables Experts North America Inc., 271 East 2nd
Street, Vancouver, BC, V5T 1B8, Canada
Email: service@jilong Tel: [phone]
3