JLL CT200 User manual

When inserting the batteries
make sure they are the correct
way round
The monitor will
automatically be in ‘SCAN’
mode
Press ‘MODE’ to come out of
‘SCAN’ and keep pressing
to skip through each setting
To set a time or distance,
select the setting by pressing
‘MODE’ then continuously press
‘SET’ until the digits display
your chosen time,distance ect.
Press and hold the ‘RESET’
button to return all the
digits to zero
1. SET UP
2. BASICS
If you have any further queries please contact
our customer service team on 0121 328 7507
or email at ‘contact@jllfitness.co.uk’
CT200 MONITOR INSTRUCTIONS

Speed: Your current speed, displayed in kilometres per hour (km/h).
Distance: The total accumulated distance, in kilometres during your workout.
Calorie: The total accumulated calories burned during your workout.
Pulse: Your current heart-rate. Heart-rate will appear when a signal is detected from your hands being
placed on the sensor plates. Pulse is measured in PPM (Pulsations Per Minute).
Time: The total time you have been exercising. Display time as hours: minutes.
Scan:Scan: This function will continuously change between each setting, displaying one after the other every
few seconds.
4. DATA READOUTS
If your monitor is not displaying any readings some things to check are;
1. The wires connected during assembly are securely clipped together
2. The pins at the end of the wires are not bent in any way
3. None of the wires have been trapped in the post
3. TROUBLESHOOT