JLL IC300 User manual

If you have any further queries please contact
our customer service team on 0121 328 7507
or email at ‘contact@jllfitness.co.uk’
IC300 MONITOR INSTRUCTIONS
If your monitor is not displaying any readings some things to check are;
1. The wires connected during assembly are securely clipped together
2. The pins at the end of the wires are not bent in any way
*Please not the distance will only measure in miles and not kilometers*
The monitor will
automatically be in ‘SCAN’
mode
To exit ‘SCAN’ mode press
the single button on the
monitor, continuously press
the button until the arrow
aligns with your chosen
setting
To reset the monitor press
and hold the single button
until all of the zero’s flash
1. SET UP
2. BASICS
3. TROUBLESHOOT
W hen inserting the batteries
make sure they are the
correct way round

Speed: Your current speed, displayed in miles per hour (mph).
Distance: The total accumulated distance, in miles during your workout.
Odometer: The total accumulated distance, in miles since the machine has first been used.
This cannot be reset.
Calorie: The total accumulated calories burned during your workout.
Pulse: Your current heart-rate. Heart-rate will appear when a signal is detected from your hands being
placed on the sensor plates. Pulse is measured in PPM (Pulsations Per Minute). placed on the sensor plates. Pulse is measured in PPM (Pulsations Per Minute).
Time: The total time you have been exercising. Display time as hours: minutes.
Scan: This function will continuously change between each setting, displaying one after the other every
few seconds.
4. DATA READOUTS