Johnson & Johnson Ethicon MEGADYNE Smoke Evacuator Installation and operation manual

MEGADYNE™ Smoke Evacuator
Optimized Device Performance Guide
Before you begin
1. Plug in power cord: Insert power
plug into the receptacle on the
MEGADYNE™ Smoke Evacuator.
2. Recommended: Plug in connect
cable. Insert the male connector of
the connect cable into the
receptacle on the MEGADYNE™
Smoke Evacuator and the female
connector into the receptacle on the
electrosurgical generator.
3. Alternate: Connect RF sensor to monopolar cord. When connecting smoke
evacuator and electrosurgical generator via connect cable is not possible:
a. Insert RF sensor (sold separately)
into the RF sensor port on
MEGADYNE™ Smoke Evacuator.
b. Insert monopolar pencil cord or
return electrode cord into the
receptacle on RF sensor.
Generator
Smoke
evacuator Connect
cable

Using in open procedures
1. Press the OPEN button to switch to
OPEN mode.
3. Adjust RUN TIME settings to
user-preferred time-delay intervals.
RUN TIME options control how
long low continues after the
energy device is deactivated when
utilizing one of the automatic
activation methods. This feature
enables evacuation of residual
smoke after the surgeon discon-
tinues activating the energy device.
2. Adjust FLOW settings to user-
preferred low-rate levels.
4. Ensure smoke evacuation tube
is connected to MEGADYNE™
Smoke Evacuator.
118LPM
106LPM
94LPM
82LPM
71LPM
30 sec.
15 sec.
10 sec.
6 sec.
3 sec.
4. Insert the ilter securely into the
ilter port located on the front of the
MEGADYNE™ Smoke Evacuator.
6. Check the FILTER life indicator:5. Turn on the machine: Press the
power switch button to turn on the
smoke evacuator.
If the ilter is not securely seated,
all ilter lights will blink until proper
installation is completed.
One indicator light will be
illuminated when the ilter is secure
and indicate remaining ilter life.
a. Green
Ready for use:
100% - 25% ilter life.
b. Yellow
Ready for use:
25% - 0% ilter life.
c. Red
Once the red light is illuminated,
the smoke evacuator can only be
activated within a 3 hour window
to complete the case.
Before you begin (cont.)

If preferred, press the MANUAL
START/STOP button to activate
smoke evacuation in OPEN or LAP
mode. Smoke evacuation remains
activated until the MANUAL
START/STOP button is pressed again.
Manual activation of smoke evacuation
1. Press the LAP button to switch to
LAP mode.
3. Adjust RUN TIME settings to
user-preferred time-delay intervals.
RUN TIME options control how
long low continues after the
energy device is deactivated when
utilizing one of the automatic
activation methods. This feature
enables evacuation of residual
smoke after the surgeon discon-
tinues activating the energy device.
2. Adjust FLOW settings to user-
preferred low-rate levels.
4. Ensure smoke evacuation tube
is connected to MEGADYNE™
Smoke Evacuator.
41LPM
29LPM
18LPM
11LPM
5LPM
10 sec.
8 sec.
6 sec.
4 sec.
2 sec.
Using in LAP procedures
Please always refer to the Instructions for Use / Package Insert that come
with the device for the most current and complete instructions
Johnson & Johnson Medical Limited
Baird House, 4 Lower Gilmore Bank,
Edinburgh, EH3 9QP, UK
www.jnjmedicaldevices.com
© Johnson & Johnson Medical Limited 2020, 154866-201002 UK