Johnson Plastics Plus EMGMCB1 User manual

April-22
Faux Marble and Acacia Cutting Boards
FAUX MARBLE AND ACACIA CUTTING BOARDS - Heat Transfer (Hard Surfaces)
EMGMCB1 | EMGMCB2
GENERAL TONER HEAT TRANSFER PROCESS
Recommended Equipment & Accessories
•Heat Transfer Printer
•Heat Transfer Paper for Hard Surfaces with paper instructions
•Standard Flat Heat Press- Swing-away style press recommended
•Heat Tape

April-22
•Teflon sheet or Blowout paper
•Heat gloves
•Optional: Orange Silicone heat pad
Recommended Settings
Refer to the Heat Transfer Paper Instructions for best results.
Time
60 seconds
Temperature
300°F
Pressure
Heavy
General Heat Transfer Instructions
•Follow the Heat Transfer Paper Instructions for best results.
•Adjust press pressure to heavy.
•Preheat the heat press to 300°F or temperature specified per paper instructions.
oIf using an orange silicone heat pad, adjust temperature to 330°F.
•Print and place transfer sheet face down onto the surface of the cutting board blank. Secure transfer
with heat tape.
oTransferring an image to both the wood and marble surfaces at the same time can be done.
However, in some cases and when possible, transferring to the wood side of the coaster
separately from the marble side may yield better results, as the marble side will hold heat much
longer than the wood side.
•Place the cutting board blank with attached transfer sheet onto the heat press platen with the transfer
paper on top.
•Place a piece of Teflon or blowout paper on top of the transfer paper.
oOptional: Place an orange silicone heat pad on top of the transfer paper to help with the
downward pressure on the cutting board.
•Close and press for the recommended time.
•When finished, open the press and remove the Teflon or blowout paper.
•Using heat gloves, remove the cutting board from the press.
•Peel the transfer paper off of the surface of the cutting board while the cutting board surface is still
hot/warm.
oThe product should still be warm, but able to be handled without heat gloves.
Tips and Tricks
•For best image placement, utilize the product template found on the product page on JPPlus.com.
•If using an orange silicone heat pad, adjust temperature to 330°F.

April-22
•Transferring an image to both the wood and marble surfaces at the same time can be done. However,
in some cases and when possible, transferring to the wood side of the coaster separately from the
marble side may yield better results, as the marble side will hold heat much longer than the wood
side.
Troubleshooting
•The image did not completely transfer to the product.
oSlightly increase the press pressure.
oThe product may still be too warm when peeled. Wait a little more time before peeling the
transfer paper.
oEnsure that the Hard Surface paper used is compatible with the product material, as there are
several types of Hard Surface papers available for different types of hard surface goods.
Templates and Images
•Visit jpplus.com to find the product page for this item. The product template may be found under the
Tech Docs and Downloads area of the page.
To order more of this product, see similar products and much more, please visit jpplus.com.
For additional product support and troubleshooting, please contact JPPlus Advanced Support Team:
•Phone: [phone]
•Email: [e-mail]
•Schedule an appointment: https://jpplusadvancedsupport.setmore.com/