JOHNY VAC JVBP6 User manual

JVBP6
Backpack Vacuum Cleaner
USER GUIDE

User Guide
JVBP6
2
JVBP6
User Manual
Table of contents:
1- Backpack Vacuum Cleaner Overview ......... 3
2- Important Safety Instructions ...................... 4
3- Operations ................................................... 6
4- Maintenance and Care ................................ 7
5- Troubleshooting .......................................... 8
6- Parts List .................................................. 10

User Guide JVBP6
3
1. Backpack Vacuum Cleaner Overview
1. LID LATCH
2. SHOULDER STRAP
3. ADJUSTABLE WAIST BELT
4. SWITCH BOX
5. HOSE INLET
6. WAND
7. EXTENSION CORD
8. RUG BRUSHES
9. CREVICE TOOL
10. DUST & UPHOLSTERY BRUSHES
1
2
3
4
5
67
8
9
10

User Guide
JVBP6
4
2. Important Safety Instructions
When using an electrical appliance, basic precautions should be observed, including the
following:
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
Always connect to a polarized outlet (left slot is wider than right).
Unplug from outlet when not in use and before conducting maintenance.
WARNING:
To reduce the risk of fire, electric shock, or injury:
• Do not modify the polarized plug to fit on a non-polarized outlet or extension cord.
• Do not leave vacuum cleaner when plugged in.
• Unplug from outlets when not in use and before servicing.
• Do not use outdoors or on wet surfaces.
• Do not allow to be used as a toy.
• Close attention is necessary when used by nearchildren.
• Do nut use for any purpose other than described in this user’s guide
• Use only manufacturers recommend attachments.
• Do not use with damaged cord or plug.
• If appliances is not working as it should, had been dropped, damaged, left
outdoors, or dropped into water, have it repaired at an authorized service center.
• Do not pull or carry on a cord, use cord as a handle, close door on the cord, or pull
cord around sharp edges or corners. Keep cord away from heated surfaces.
• Do not unplug by pulling on a cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or vacuum cleaner unit with wet hands.
• Do not put any object into openings. Do not use with any opening blocked; Keep
free of dust, lint, hair and anything that may reduce airflow.
• Keep hair, loose clothing, fingers and all parts of body away from openings and
moving part.
• Turn off all controls before plugging or unplugging vacuum cleaner.
• Use extra care when cleaning on stairs.

User Guide JVBP6
5
• Do not use to pick up flammable materials (lighter fluid, gasoline, kerosene, etc )
or use in the presence of liquids or vapours.
• Unplug before connecting the hose.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches,
or hot ashes.
• Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.)
• Do not use vacuum cleaner in an enclosed space filled with vapours given off by
oil base paint, paint thinner, some moth proofing substances, flammable dust, or
other explosive or toxic vapours.
• Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches,
or hot ashes.
• Do not use without filters in place.
• Keep appliances on a level surface.
• Do not carry the vacuum cleaner while it is running.
• Do not operate cleaner in bare feet or when wearing open-toe shoes or sandals
• Do not use without dust bag or dirt cup in place. Shake bags and empty dirt cup
frequently when picking very fine materials such as powder.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
This model is for commercial use.
Grounding Instructions
This appliance must be grounded. If it should malfunction or break down, grounding
provides a path of least resistance for electric current to reduce the risk of electric
shock. This appliance is equipped with a cord having an equipment-grounding conductor
and grounding plug. The plug must be inserted into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and ordinances.

User Guide
JVBP6
6
WARNING:
IMPROPER CONNECTION OF THE EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN A
RISK OF ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE PERSON
IF YOU ARE IN DOUBT AS TO WHETHER THE OUTLET IS PROPERLY GROUNDED. DO NOT
MODIFY THE PLUG PROVIDED WITH THE APPLIANCE – IF IT WILL NOT FIT THE OUTLET, HAVE
A PROPER OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN. THIS APPLIANCE IS FOR USE
ON A NOMINAL 120-VOLT CIRCUIT, AND HAS A GROUNDED PLUG THAT LOOKS LIKE
THE PLUG IN THE DRAWING ABOVE. NO PLUG ADAPTER SHOULD BE USED WITH THIS
APPLIANCE.
3. Operations
1. Release the two latches and lift off the lid to ensure
that the micro filter cloth bag and the disposable
bag are inside. Once checked replace the lid back
and lock the latches.
2. Both the micro filter cloth bag and disposable bag,
filter the air while holding all debris. The micro filter
with its rubber top provides the seal for the vacuum
while also filtering the air. Replace or empty each
as necessary.
3. Make sure the lid is locked on the vacuum. Take
the vacuum hose and push it into round opening on
top of the lid.
4. Connect the extension cord to the power cord
located by the switch box.
5. The receptacle on the switch box can be used with
the optional powerhead for deep cleaning.
6. Put back pack on and adjust shoulder straps and
waist belt until it’s comfortable. The harness is
made for custom fit.
7. Attach hose to commercial wand. Attach desire
tools to bottom of the wand by loosening nuts and
pushing in the tool. Tighten nut until tools in place.
Tools will swivel when using side to side motion.
Note: never take note off wand or risk losing
metal ring inside nuts. The metal ring holds
tools in place in its slotted groove.
1
3

User Guide JVBP6
7
8. Plug the extension cord into a
properly installed outlet.
9. Press the power switch
located on the switch box
to “on” or “off” position to
operate.
10. When vacuuming, use a for-
ward and backward motion.
4. Maintenance & Care
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY, TURN POWER OFF AND
DISCONNECT PLUG FROM ELECTRICAL OUTLETS BEFORE PERFORMING MAINTENANCE OR
TROUBLESHOOTING
To change the filter bag:
1. Shut off the power switch and unplug all cord
from outlets and vacuum.
2. Check disposable bag to see if it is full. Always
change disposable bag when it is full, discard
and replace with a new one.
3. Do not reuse disposable bag - this affects the
filtration of the backpack.
4. Always check the micro filter cloth bag
each time when you replace the disposable
bag. Clean or change it as necessary.
Clean the cloth bag by simple shake it well.
Note: very fine powders and substances
may clog the bag. Please remember to
empty bag often so that vacuum cleaner
can efficiently operate.
2
7

User Guide
JVBP6
8
Power cord and storage:
1. Always unwind the extension cord completely before vacuuming.
2. Never stretch or pull the cord tightly, this will damage the cord and create a danger.
3. Always unplug vacuum when not in use.
4. Always check the condition of all electrical cords before use. Never use if it ripped or
has a tear.
5. Unplug extension cord wrap loosely when it is not in use - when backpack vacuum is
not in use, always store in a dry area or place.
Note:do not repair if you are not an authorize technician familiar with the commercial
backpack. Do not lubricate the motor. It is equipped with sealing bearings.
5. Troubleshooting
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY, TURN POWER OFF AND
DISCONNECT PLUG FROM ELECTRICAL OUTLETS BEFORE PERFORMING MAINTENANCE OR
TROUBLESHOOTING
Low suction or poor pick up
POSSIBLE CAUSES: REMEDIES:
DISPOSABLE DUST BAG IS FULL DISPOSE CURRENT DISPOSABLE BAG AND
REPLACE WITH NEW
WAND IS NOT PROBABLY INSTALLED SECURE PROPERLY TO ENSURE NO AIR LEAKS
TOOL NOT WORKING PROPERLY MAKE SURE TOOL IS ON THE WAND PROPERLY
AND TIGHTLY
AIR PATH OBSTRUCTED CHECK FOR ANY AIRFLOW OBSTRUCTIONS

User Guide JVBP6
9
Vacuum motor is not working
POSSIBLE CAUSES: REMEDIES:
VACUUM IN NOT PLUGGED IN CHECK TO MAKE SURE VACUUM IS PLUGGED
PROPERLY
ELECTRICAL OUTLETS IS NOT
WORKING
CHECK ELECTRICAL SOURCE
MOTOR THERMAL PROTECTOR
ACTIVATED DUE TO BLOCKAGE
ALLOW CLEANER TO COOL DOWN, AND
CHECK THE VACUUM DUCTS AND FILTER FOR
BLOCKAGE
ON/OFF SWITCH FAULT CONTACT AN AUTHORIZED SERVICE CENTER
MOTOR DEFECTIVE CONTACT AN AUTHORIZED SERVICE CENTER

User Guide
JVBP6
10
-
-
-
-
-
-
-
-
-
-
-
--
-
-
-
-
-
-
-
-
-
-
-
-
-
6. Parts List
BX-1 Hose assembly
BX-2 Lid
BX-3 Paper bag
BX-4 Cloth bag
BX-5 Lid latch assembly
BX-6 Lid latch screw
BX-7 Body
BX-8 Bag support screw
BX-9 Bag support
BX-10 Motor shroud seal
BX-11 Motor
BX-12 Exhaust sponge
BX-13 Bottom cover
BX-14 Bottom cover screw
BX-15 Grounding screw
BX-16 Grounding nut
BX-17 Motor mount
BX-18 Thermal baffle
BX-19 Motor seal
BX-20 Noise muffle sponge
BX-21 Motor shroud
BX-22 Pre motor filter
BX-23 Switch box assembly
BX-24 Switch box assembly
BX-25 Waist belt mounting
plate
BX-26 Waist belt screw
BX-27 Carry handle screw
BX-28 Carry handle
BX-29 Shoulder strap screw
BX-30 Shoulder strap
BX-31 2 Pieces aluminum
wand
BX-32 Crevice tool
BX-33 Bare floor brushl
BX-34 Upholstery brush
BX-35 Rug brush
BX-36 Dusting brush

JVBP6 - EN
FOR
PARTS, ACCESSORIES & VACUUM BAGS
VISIT OUR WEBSITE AT
WWW.JOHNNYVAC.COM
Residential and commercial
vacuum cleaner specialist