Jojo QB60 Maintenance and service guide

Installation
& maintenance
of your JoJo
Booster Pump
Note: The test can be performed without connecting
the pump to the water supply.
1. After your pump has been cleaned and
re-assembled it is now ready to be tested. As
mentioned, this is done whilst the pump is not
connected to the tank.
2. Insert the plug into the main power supply and
switch it on. The pump should start up immediately
and run for 20 seconds.
3. As per the built in safety feature, the pump should
shut down automatically after 20 seconds. To reset
the pump, press the reset button on the pressure
switch.
04
Testing your pump
after cleaning it
Ensure that you have followed the
cleaning instructions provided.
[phone] | www.jojo.co.za
STEP 8
Replace the front cover and refit the 3
x 6mm screws to the front cover.
STEP 7
Make sure the “O” ring as
indicated on the photo is in place
before re-fitting the front cover.
STEP 6
Clean behind the impeller and casing
with the sandpaper as indicated. Then
clean both sides with a cloth.
Your pump is now ready to be
re-assembled.
STEP 5
Use a piece of sandpaper and gently
clean the surface where the impeller
runs.
STEP 9
Tighten the 3 screws on the cover,
making sure you do not overtighten
them.
STEP 4
If dirt is visible on the wear-plate and
impeller as indicated then refer to
step 5.

03
Cleaning your pump
A CLEAN
CLOTH
SIZE 8
SPANNER
FLAT POINT
SCREW DRIVER
WATER PUMP
PLIERS
100/120 GRIT
SAND PAPER
You will require the following:
1. When Installing the Pump
Ensure that the water level in the tank is higher
than the suction side of the pump.
2. When Switching on the Pump
• Check that the ball valve between the tank
and the pump is open, and that the top ball
valve on the pump is closed.
• Insert the plug into the main power supply
and switch the plug on.
• Open the top ball valve on the pump.
The pump should start automatically.
• Note: In the event of the pump running dry, it
will stop after 20 seconds (this is a built in
safety feature that protects the pump).
To reset the pump, you will need to press
the reset button on the pressure switch.
3. Maintaining the Pump
Important: The pump should run at least once a
week to stop the impeller from getting stuck (this
is normally caused by sediment in the water).
If the pump does not run as per the above, it needs
to be cleaned. Refer to section 3 of this leaflet
for detailed cleaning instructions.
01
Basic installation
guidelines
It is important to take note
of the following:
PAIR WITH OUR PUMP
TO TANK CONNECTOR KIT
• Pressure range 1 to 3.8 bar
• Flow 34 lt/min
• Brass impeller/liner
• Stainless shaft
• Unit intended for clean water
us age such as drinking water or
non-potable water piping systems.
• This unit is not suitable for
medium to large scale
irrigation systems.
Provides reliable water pressure while
using minimal energy.
Pump Model
Motor Power
Max. Flow
Max. Pressure
QB60
0.37kW | 05 HP
34 lt/min
3.8 Bar
02
Booster Pump
specifications
New advanced technology with
class leading performance.
STEP 2
Split the front cover from
the pump.
STEP 1
With the pump outlet facing you,
remove the 3 x 6mm screws from
the front casing.
STEP 3
Move the cover away from the pump.
Be careful not to damage the electric
cord.
[phone] | www.jojo.co.za