JOLIN LAB BATA User manual

JOLJN LAB
BATÀ
build guide v1.0
∞
Hi fellow!
Just a quick intro before starting,
A useful tool that can help you find the components on the boards is the interactive BOM linked
here:
tinyurl.com/batabom
Download it and open the .html file with a browser. You can use it to check where a component is
located on the board. It works also offline.
now let’s begin!

resistors:
They are placed in vertical position.
The body of the resistor goes on top of the white circle marked on the PCB.
If two resistors are placed mirrored one in front of the other and both their legs don’t fit into the hole
don’t worry: cut the bent leg of one of the two resistors and solder it from the top.
tip: they don’t have a polarity; this precaution is due to avoid them touching while soldered.
2
R19, R20
33r
3
R7, R8, R9
100r
1
R18
649r
8
R2, R5, R6, R11, R14, R15, R17, R22
1k
8
R1, R3, R4, R10, R12, R13, R16, R21
2.2k
8
R23, R24, R25, R26, R27, R28, R29, R30
100k

film capacitors:
Snap them in. Don’t mind their polarity.
8
C1, C2, C3, C4, C5, C8, C9, C10
100n
2
C6, C7
220n
1
C12
470n
1
C11
680n
vactrols:
Match the short leg of the vactrol with the squared solder pad on the PCB.
tip: it’s easier to bend at 90° degree all the four legs before trying to fit the vactrol in place.
8
U1, U2, U3, U4, U5, U6, U7, U8
VTL5C1
ok, flip the board. we are almost done
jack sockets:
Wait to solder them: just place all of them in the right place and move to the next step.
24
J1, J2, J3, J4, J5, J6, J7, J8, J9, J10, J11, J12, J13, J14, J15, J16, J17, J18, J19,
J20, J21, J22, J23, J24
PJ398SM
LEDs:
Short leg goes into the square pin. Don’t solder them yet
2
D1, D4
Green_3mm
2
D7, D8
Yellow_3mm
2
D3, D5
Orange_3mm
2
D2, D6
Red_3mm

At last put the panel on - check its direction - tighten the
nuts and then solder all the jacks and LEDs -the closer to
the panel, the more they will be evident on the panel’s
hollow line.
tip: we are soldering them now to ensure that all the jack
sockets and LEDs are aligned with the panel
check if everything is in place
done! enjoy your new
BATÀ
find us:
web ⇒www.jolinlab.com
e-mail ⇒[email protected]
Instagram ⇒@jolinlab