Jorgenson Lockers Kids Sports Locker User manual

Assembly Instructions
1
Jorgenson Kids Sports Locker
Tip: Ensure that the
bolts are installed
on the outside of
locker and nuts
are secured on the
inside of the locker.
TIP:
Identify Parts
Start Assembling
Remove unassembled locker parts from the
packaging. Next, locate and identify each part
based on the images show below:
• Position the back panel on straight, even flooring or pair of saw horses.
• Gently bolt the left and right side panel to the inside of each back panel
(1) Front Door (1) Back Panel (2) Side Panels (2) Top/Bottom Panels
Top/Bottom are identical
Left Side Panel
Top holes are 1/2”
at the top of each
panel shown.
View of locker with back panel
at on oor or saw horses
The left and right side panels
must be placed inside the
back panel flanges.
Side Panels
Back Panel
Right Side Panel
(1) Hat Shelf
Bolt the tamper-proof
screw on the inside
of the locker. Only the
screw heads should
be visible from the
outside of the locker.

Assembly Instructions
2
Jorgenson Kids Sports Locker
Continued Assembly
• Slightly bolt the top panel, hat shelf, and bottom panel inside the side and back panel.
Note:
Top and bottom panels have two (2) round,
pre-drilled holes that can be found on the
back flange and are designed to bolt to the
back panel.
Insert Front Door Frame
• After the top and bottom panels have been attached, pro-
ceed to insert the door frame on the outside of the left, right
and bottom panels.

Assembly Instructions
3
Jorgenson Kids Sports Locker
Insert Front Door Frame
• Place locker in the upright position and make sure locker is level.
• When locker is level, test the door to determine it opens properly. Bolts can be adjusted if there
are any problems with opening and closing.
• Once the door is functioning correctly, tighten all bolts.
• To instill proper safety measures, we highly advise anchoring the locker to the floor or wall to
avoid injury or theft.