JSG A2 User manual
USER GUIDE
A2 CONTROLLER
JSG Industrial Systems | www.jsgindustrial.com
Quality Engineered Systems
SET UP:
To enter setup mode hold down
the middle button (6) for 5 seconds.
In this state the user can scroll up and down through
the various settings options by pressing the up (7) and
down (6) buttons. To adjust the setting, use the enter (4)
button to move the cursor to the right side and select by
moving through options with the up or down buttons.
To accept the change, press the enter button which will
move the small cursor back to the left side as illustrated
in the image above.
Run
Mode
1
2
3
4
5
6
7
8
External
Warning
Pause
Mode
Motor Open
Circuit
System
Selection
Motor Short
Circuit
Low
Level
Blockage
Detection
Vent
Time
Test
Mode
Proxy 1 Proxy 2
1. Lexan Decal
2. Engineered ABS Resin Enclosure
3. LED indication for Power, Pump Status and Fault
4. Enter button for selection
5. Buzzer on for faults
6. Button to scroll down for selection (Mute)
7. Button to scroll up for selection (Run/Pause)
8. OLED Display
NOTE:
Cursor on left will
flash Menu Mode
SPECIFICATIONS:
VOLTAGE:
10.5VDC TO 30VDC
CURRENT DRAIN:
15mA MAX (no load) 10mA nominal
PUMP OUTPUT:
12A Continuous,15A
for 15 sec, 20A for 6 Sec
LAMP OUTPUT:
5A MAX
SWITCHING:
Solid state short circuit protected
FUSE:
Electronic Fuse (60A)
TEMPERATURE RANGE:
-30˚C to 60˚C
CONNECTION:
14 way MOLEX MINIFIT - JR
COMMUNICATIONS:
RS232 Type
BLUE TOOTH:
LE Connection
(Low Energy Interface)
Range > 20m
DIMENSIONS:
95 mm X 78 mm X 38 mm
(including mounting bracket)
WEIGHT:
120g
PROTECTION:
IP54
USER GUIDE
A2 CONTROLLER
Quality Engineered Systems | www.jsgindustrial.com
CABLE TYPE CONDUCTOR SIZE MAXIMUM CABLE LENGTH
6A PUMP LOAD
MAXIMUM CABLE LENGTH
12A PUMP LOAD
12 CORE 1 mm26 m 3 m
Single Line System wiring diagram with 1 pressure switch
12V INSTALL WITH HARNESS 13-002600-2 (HARNESS LENGTH IS 7M)
24V INSTALL WITH HARNESS 13-002600-2 (HARNESS LENGTH IS 7M)
Progressive Line System wiring diagram with sensors
SCAN the QR CODE
for link to Bluetooth APP, support & detailed manuals:
NOTE: A2 IS OFF WHEN POWER IS OFF
NOTE: A2 IS OFF WHEN POWER IS OFF
12 CORE 1 mm212 m 6 m
*Refer to the full manual when wiring pumps at a greater distance from the controller. Correct size cables must be selected to join onto the harness
meeting the required max current draw.
WARNING:
Never weld on a machine while the main switch of the machine is on. Ensure that the machine main
switch is off and correctly tagged. Welding on a machine can cause serious damage to the A2 controller
Do not alter or modify any part of the A2 controller
Ensure that the A2 controller in mounted in an suitable area
Do not mount the A2 controller near excessive heat areas
Always use the specified fuse rating for the A2 controlle
Never exceed the voltage rating of the A2 controller
Never expose the A2 controller to water or other substances
