Jupiter SRX3400 User manual

Replacing an AC Power Supply on the SRX3400 Services Gateway
To replace an AC power supply:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see Preventing Electrostatic Discharge Damage to the SRX3400
Services Gateway.
2. Remove the power cord from the power supply.
3. Push the tab on the left edge of the power supply to the right.
4. Pull the power supply straight out of the chassis using the provided handle. Use
one hand to support underneath the supply as you remove it.
Figure 1: Removing an AC Power Supply
g036018
5. Orient the replacement power supply so that the tab is on the left side, as shown
in Figure 2.
Replacing an AC Power Supply on the SRX3400 Services Gateway ■1

Figure 2: Inserting an AC Power Supply
g036017
6. Using both hands, slide the replacement power supply straight into the chassis
until the power supply is fully seated in the chassis slot. Make sure the tab on
the left edge of the power supply clicks into place. The power supply faceplate
should be flush with any adjacent power supply faceplate.
NOTE: Be sure to have the power supply oriented correctly. The tab must be on the
left and click into place when fully seated. If the power supply does not insert easily
or does not become flush with the chassis, you may have the power supply upside
down.
7. Attach the power cord to the power supply. If the power supply is correctly
installed and functioning normally, the power supply powers up immediately.
NOTE: You must have an SFB and a Routing Engine installed in the services gateway
for the power supply to turn on automatically.
NOTE: If you were moving this power supply from one slot to another, wait at least
60 seconds before inserting it into the new slot.
Related Topics Required Tools and Parts for Replacing Hardware Components on the SRX3400
Services Gateway
■
■Replacing AC Power Supply Cables on the SRX3400 Services Gateway
Published: 2010-04-20
2■Replacing an AC Power Supply on the SRX3400 Services Gateway