Justin Jf-460-2600 User manual

BEFORE INSTALLING AND USING THE PRODUCT,

PLEASE READ THE INSTRUCTIONS THOROUGHLY,

AND RETAIN THEM FOR FUTURE REFERENCE.

PRODUCT OVERVIEW

Included: (1x) Flashlight Power Bank, (1x) USB Charging

Cable and (1x) Nylon Lanyard

SPECIFICATIONS

To ensure safe operation, check your device’s

compatibility with Flashlight speciﬁcations prior to use.

CHECKING POWER LEVELS

USE

Before ﬁrst use, it is recommended to charge the

Flashlight via the Micro USB Input Port with the supplied

Micro USB Cable. The Flashlight will take approximately 4

hours to charge from 0-100%.

. Charging the Flashlight:

Plug the supplied Micro USB Cable into the Flashlight’s

Micro USB Input Port. Next, insert the USB end of the

charging cable into a computer or AC power source

with a USB Output Port of 5V. While charging, the 3

blue LED Indicator Lights will FLASH to show the

power level. When the Flashlight is fully charged, all 3

LEDs will stop ﬂashing and stay lit. See “Checking

Power Levels”

2. Charging Your Smartphone, Etc:

Using your device’s supplied charging cable (Apple®

Lightning™cable, Micro USB cable, etc.), plug your

smartphone, tablet or other USB powered device into

the USB Output Port of the Flashlight. Press and Hold

the Power Button on the Flashlight for Two Seconds to

begin charging your device. The Green LED will turn on

and remain on to indicate your device is charging.

Charging will continue until your device is fully charged

or the Flashlight’s internal battery has drained.

Important: Please check voltage compatibility with your device

prior to use.

3. Using the Flashlight:

Disconnect all cables and devices from the Flashlight

before use. The LED Torch is operated by pressing the

Power Button. The Flashlight operates in four light

modes: Normal, Extra Bright, Flashing, SOS & OFF.

Push the Power Button to cycle through each light

mode. To stop charging or turn OFF the Flashlight at

any time, push and hold the Power Button for Two

seconds.

Please Note: The Green LED will remain lit brieﬂy.

LED FLASHLIGHT / BATTERY LIFE

PLEASE NOTE

• The Flashlight comes pre-packaged with a partial charge,

NOT a full charge. We recommend fully charging your

Flashlight before ﬁrst use for best performance.

• The Flashlight’s LED Indicator represents the estimated

power levels. Actual charge may vary.

• If your device (smartphone, tablet, etc.) is not charging,

this may be a sign that the battery level of the Flashlight

is very low and needs to be recharged.

• It is normal for the Flashlight to become slightly warm

during use.

•

The Flashlight has an Over-Charge Protection circuit to

help prevent damage to the internal battery when charging.

• The Flashlight cannot charge an external device while

charging the internal battery via the Micro USB Input Port.

• The Flashlight can NOT charge any external devices

while using the LED Torch.

• Your Power Bank includes a special built-in Micro USB to

USB cable. Some devices, namely BlackBerry® devices,

REQUIRE this cable for charging. If you do not use this

supplied cable, your device might not charge.

• In some instances, some older Samsung®Tablets require

you to turn OFF the tablet prior to charging.

MAINTENANCE

In order to keep your Flashlight operating at maximum

potential, please follow these guidelines:

1. Recharge the Flashlight every 2 months when not in use.

Charge to at least 40%, as this will extend the battery life.

2. Keep your Flashlight dry and away from moist and

corrosive materials. DO NOT get wet. In addition,

never expose to high heat environments. Avoid extreme

temperatures of hot or cold as it will decrease the overall

battery performance.

CAUTIONS

Please read this section carefully before using.

• Only use this product with conﬁrmed power sources that

follow device speciﬁcations. Device is intended to be

used with iPhone®, mobile phones and other digital

products. Only use speciﬁed charging methods or

reputable branded chargers that are compatible with

speciﬁed device speciﬁcations.

• Do not use product beside or in close proximity to a heat

source such as a ventilation heat vent, convection heater,

burner, etc.

• Do not expose device to moisture or submerge it in liquid.

Do not leave device inside an excessively hot or cold

environment. Store device in a cool and dry environment

at all times.

• Avoid dropping or applying excessive shock and force to

device. Do not use in unprotected outdoor environments

or in exposed sunlight for a prolonged period of time.

• Do not use device in a conﬁned space. Restricted or

insufﬁcient airﬂow will put device at risk of overheating.

• Avoid touching metal prongs when plugging and

unplugging device from power source.

• Do not use harsh chemicals to clean device. Use a damp

cloth with warm water to wipe off any dirt. Only clean the

device when it is unplugged from any power source.

• Ensure charge port is clear of any foreign objects before

using. Do not force incompatible connectors into any port.

• Do not used damaged cables and wires with device.

• Do not attempt to disassemble the device. Any attempts

to do so will void all warranties on this product. Do not

attempt to remove or salvage batteries for other purposes.

• Never look into light beam directly or with optical

instruments. Point light beam so that it is directed below

eye level.

• Do not point the light beam at mirrors or other reﬂective

surfaces.

• Never point the light beam directly at a person or an

animal. The light beam can cause damage to eyes or skin.

• Please also observe the safety and operating instructions

of any other devices which are connected to the product.

• When traveling, keep the ﬂashlight in a case to avoid the

ﬂashlight accidentally being turned on, which may drain

battery, or cause a ﬁre.

• The device is not a toy. Keep it out of the reach of

children and pets.

SAFETY INSTRUCTIONS

Read all instructions and warnings prior to using this

product. This device contains a Lithium Ion (Li-ion)

Battery. Improper use, storage and disposal may cause

leaks, expansions and explosions that could lead to ﬁres,

health concerns, bodily injury and property damage.

• Upon the event where the device may be broken, shattered,

or in any way physically compromised DO NOT USE.

• Do not dispose device into standard garbage disposal sites.

Dispose of device at available Battery Recycling Sites after

fully discharging battery. Not doing so may violate local

disposal laws and regulations.

• NOTE: Opening of product and/or removal of battery will

render product inoperative and voids manufacturer

warranties, dispose of remaining product components in

accordance with local laws.

• If unusual expansion is detected, disuse device immediately.

In case of ﬁre, use lithium approved “Class D Type” Fire

Extinguishers on device.

• Do not expose or dispose of device into ﬁre.

• In the unfortunate case of a leak and electrolyte comes in

contact with skin, wash area with water and soap.

If electrolyte makes contact with eyes, ﬂush with generous

amounts of water for 15 minutes and seek medical attention

immediately. Avoid inhaling fumes if applicable. Do not

attempt to reuse damaged device.

• Do not charge device with unspeciﬁed power source. Only

use speciﬁed method of charge and reputable brand OEM

chargers compatible with device speciﬁcations.

FCC STATEMENT

Warning: Changes or modiﬁcations to this unit not expressly

approved by the party responsible for compliance could void

the user authority to operate the equipment.

NOTE: This equipment has been tested and found to

comply with the limits for Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference

in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions,

may cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on. The user is encouraged to try to

correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC

RULES. OPERATION IS SUBJECT TO THE FOLLOWING

TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE

HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST

ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING

INTERFERENCE THAT MAY CAUSE UNDESIRED

OPERATION.

CALIFORNIA PROP 65 WARNING

WARNING: This product contains chemicals known to

the State of California to cause birth defects or other

reproductive harm. For more information on these

regulations and a list of chemicals, log on the following

website address: http://www.oehha.ca.gov/prop65.html

INNOVATIVE TECHNOLOGY ELECTRONICS CORP.

LIMITED WARRANTY: 90 DAYS LABOR, ONE YEAR PARTS

Innovative Technology Electronics Corp. (IT) warrants the product to be free from

“Defects” in materials under normal use for a period of “One Year” from the date of

the original purchase. The Warranty is “Not” transferable. IT agrees, within the initial

“90 Day” period, to repair or replace the product if it is determined to be defective at

“No Charge”. It is further agreed that IT will cover the cost to repair or replace

damaged “Parts” only for a total period of “One Year” from the date of the original

purchase. The warranty does not cover cosmetic damage, antennas, AC cords,

cabinets, headbands, ear-pads, or damage due to line power surges, connection to

improper voltage supply or settings, misuse, mishandling, accident, acts of God or

attempted repair by an unauthorized service agent.

To obtain service, the purchaser MUST present an original sales receipt / proof of

purchase. Please contact us at www.ithomeproducts.com to request an RMA (Return

Material Authorization) number to return products for service or replacement. Returns

without an RMA number on the package will be refused and returned to sender.

Upon receipt of the returning item and our full inspection (IT) may issue a

replacement to customer for the same item or of one that has equivalent value and

features. To return an item, supply full name, return address, phone number, item

purchased, receipt of purchase and reason for return to obtain RMA number.

All returns must be in the original packaging or reasonable substitute to prevent

damage. Customer “Must” include full name, shipping address and telephone

number inside of package. No return will be shipped back to a PO Box or

APO address.

Please include your check or money order in the amount of:

•USD$5.00 for items $10.00 to $39.99 (Price Paid Per Unit)

•USD$10.00 for items $40.00 to $99.99. (Price Paid Per Unit)

•USD$16.00, for items $100.00 and up. (Price Paid Per Unit)

•Shipping fees are non-refundable

To be payable to Innovative Technology Electronics Corp.(for handling and return

shipping charges) (IT) will not be responsible for delays or unprocessed claims

resulting from a purchaser’s failure to provide any / all of the necessary information.

Send all inquiries or RMA request via our website:

www.ithomeproducts.com/support.

Innovative Technology Electronics Corp.

1 Channel Drive, Port Washington, NY 11050

Toll free: 1-877-483-2497

Website for support: www.ithomeproducts.com/support

There are no express warranties except as listed above.

REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE

EXCLUSIVE REMEDY OF THE CUSTOMER, (IT) SHALL NOT BE LIABLE FOR ANY

INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR

IMPLIED WARRANTY ON THIS PRODUCT EXCEPT TO THE EXTENT PROHIBITED BY

APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO THE

DURATION OF THIS WARRANTY.

Some states do not allow the exclusion or limitation of incidental or consequential

damages, or limitations on how long an implied warranty lasts, so the above

exclusions or limitations may not apply to you. This warranty gives you specific legal

rights and you may also have other rights, which vary from state to state.

NOTE: As a result of continual improvements, the

design and speciﬁcations of this product are

subject to change without notice.

Apple and iPhone are trademarks of Apple Inc., registered in the U.S.

and other countries. Lightning is a trademark of Apple Inc.

Smartphones and Tablets are NOT included.

CAN ICES-3 (B) / NMB-3 (B)

2,600mAh LED Flashlight

with Smartphone Charger

Model:

JF-460-2600

USER MANUAL