JVA Wi-Fi Anywhere WA50 User manual

JVA Solar Wi-Fi Anywhere
Quick Start Guide
WA50
PTE2702
The JVA Logo is a registered trademark of JVA Technologies
© JVA Technologies

Page 2
Introducon
The PTE2702 JVA Wi-Fi Anywhere (WA50) provides an integrated Wire-
less Cellular USB Dongle (Wingle) power supply with a solar baery char-
ger and management system.
This product provides a Wi-Fi network wherever a 3G/4G signal is avail-
able*. The Wi-Fi can then be used to connect an IP device or Internet of
Things (IoT) device to the Cloud (Internet).
The JVA Solar Wi-Fi Anywhere is installed with an ALDI SIM card at the
factory, all you need to do is:
1. Register the SIM card
2. Connect any Wi-Fi enabled device to the network provided
This quick-start guide explains how to deploy your WA50 and connect a
baery ready for Wi-Fi connecons.
*An external cellular antenna (included) may be connected to increase
recepon. An upgraded YAGI style antenna is available from sales@jva-
fence.com.au
Specicaons
Component Informaon
Solar Panel Nominal 12v Solar Panel
(maximum open circuit voltage - 22v DC)
Maxmium Power 50W
Baery Nominal 12.8v DC
Minimum Baery size 75Ah
A larger baery may be required if any addiontal
12v device is connected to the baery
Outputs(1) 12v DC SAE Connector
Used for powering the IP Monitor

Page 3 JVA WA50
Component Informaon
Outputs (2) 12v DC Baery Connector
Alligator clips for baery connecon
SIM Full Size
Wi-Fi 2.4GHz b/g/n
Up to 10 connecons at a me
Network
(Huawei E8372)
3G 850/2100MHz
4GX 700MHz + 4G B1/3/7/21
Antenna Connector Female SMA
Ensure antenna is mounted away from sources of
interference such as AC or high voltage cables.
Troubleshoong
Fault Likely Cause Remedy
No lights are on Power is not connected
Power wires are re-
versed
Check power connec-
ons
Check baery polarity
Ba level ashing Baery disconnected
Bad baery
Check baery connec-
ons
Check baery voltage
USB_5V LED o USB device drawing
too much current
Unplug USB device,
check for damage/
seek manufacturer
advice

Page 4 © JVA Technologies www.jva-fence.com
Fault Likely Cause Remedy
Baery not charging Solar wiring backwards
Broken cables
Solar panel broken
Check that the Solar +
goes to the le-hand
screw terminal
Check that the baery
cables are not dam-
aged
Check solar panel for
physical damage (bro-
ken glass, bent frame
etc.)
Cannot connect to
Wi-Fi
Low signal from 3G/4G
Out of Wi-Fi range
(~10m)
SIM card not inserted
correctly
Check management
page of Wingle
Move closer to Wingle
Re-insert SIM card
If the unit is sll not working correctly, contact your nearest JVA distribu-
tor for technical support.
Before you start
Acvate the SIM card
Acvate your SIM card and test it in a mobile phone. The Wi-Fi network
allows a data-only connecon, the number of devices connected to the
module will determine how much data will be used.
As a guide, a single IP Energiser or IP Monitor will use less than 1MB per
day, so for connecng a single IP Energiser, an upper limit of 500MB per
year is an opon with a lot of headroom.

Page 5 © JVA Technologies www.jva-fence.com JVA WA50
Deployment and Orientaon
1. Unpack the solar kit from it’s packaging. Look inside the packaging for a set
of U-Bolts.
2. Remove the U-Bolts from the zip lock bag and mopunt it to the top and bot-
tom panel of the bracket.
(A) U-Bolt x 2 (B) Top or Boom Panel
(C) Washers x 4 (D) Spring Washers x 4 (E) Hex Nut x 4

Page 6 © JVA Technologies www.jva-fence.com
3. Loosen the 6 bolts on the inside of the frame that are used to hold the
solar panel at a right angle. DO NOT completely remove these bolts.
4. Li the boom of the solar panel unl the aached arms holding it are
angled at 90 degrees. Tighten all 6 bolts again from step 3.

Page 7 © JVA Technologies www.jva-fence.com JVA WA50
5. Aach the red and black eyelet crimps to the baery
To nd a baery that will suit you, visit our website:
hps://jva-fence.com.au/solar.php

Page 8 © JVA Technologies www.jva-fence.com
6. Alternave wiring:
The following diagram shows an alternave method for wiring the Solar Kit. The
baery is connected directly to the solar kit and the Wi-Fi device.
The solar kit will have a spare connector (load cable), but the solar kit will sll
operate properly.

Page 9 © JVA Technologies www.jva-fence.com JVA WA50
Overview

Page 10 © JVA Technologies www.jva-fence.com
LED Indicators
D1 (Solar) Solid on when solar panel in sunlight
Blinking when solar panel in low power condions
O when no solar power detected
D6 (USB_5V) Solid on when USB Power is turned on
Ba Level Boom LED ashes if no baery is disconnected or bad
Shows baery level from boom to top: 25% to 100%

Page 11 © JVA Technologies www.jva-fence.com JVA WA50
JVA Distributors
If you have quesons or need further assistance, please email us at sales@
jva-fence.com.au or call
Region Number
Australia 0731 030 582
South Africa 0861 782 349
World Wide [phone]
For more informaon on our complete range of electric fencing products
please see the JVA website at hps://www.jva-fence.com.au

Tel : [phone] Email : [email protected]om.au
www.jva-fence.com
The JVA Logo is a registered trademark of JVA Technologies
© JVA Technologies