Küppersbusch KD 9570 OBC Operation manual

BEDIENUNGSANWEISUNG
mit Montageanweisungen
Instrucciones de Uso y de Montaje
Instructions for use and installation
Instructions d΄utilisation e avis de montage
Instruções de utilizaçao e instalaçao
KD 9570 OBC
KD 9570 OJ
(Rev. 0)

10
ENG
Dear client
Congratulations on your choice. We are sure
that this modern, functional and practical
appliance, made with top quality materials,
will fully satisfy your needs.
Please read every section of this
INSTRUCTIONS MANUAL before using your
kitchen hood for the first time, to ensure
maximum performance from the appliance
and to avoid breakdowns, which may be
caused by incorrect use, as well as to allow
any minor problems to be solved.
Store this manual, as it will provide useful
information about your kitchen hood at all
times and will also help other people to use it.
• Please be aware of current local
regulations with reference to domestic
electrical fittings and gas eduction.
• Verify that the tension and frequency of the
network match those indicated on the label
located inside the kitchen hood.
• If the supply cable is damaged it should be
replaced by the manufacturer, the after-
sales service or a suitably qualified person
in order to avoid hazard.
• Once the kitchen hood has been installed,
ensure that the mains cable to the network
is not in contact with any live metal edges.
• Avoid connecting the appliance to
conductors used as exits for fumes
produced by a non-electric energy source,
e.g.: boilers, chimneys, etc.
• If the extractor fan is going to be used
simultaneously with equipment powered by
a non-electric energy source, e.g.: gas
cookers, then the room must have
sufficient ventilation.
• Excessive fat accumulation in the kitchen
hood and metal filters is a fire risk and may
also cause dripping, therefore the inside of
the kitchen hood and the metal filters must
be cleaned at least once a month.
• The lower part of the kitchen hood must be
fitted at least 65cm. over gas or mixed
hobs. FOLLOW T E OBS´ MANUFAC-
TURER'S MINIMUM RECOMMENDA-
TIONS.
• Never leave gas hobs lit if not covered by a
container. The fat accumulated in the filters
may drip or catch fire when the
temperature increases.
• Avoid cooking under the kitchen hood if the
metal filters are not fitted, e.g.: while they
are being cleaned in the dishwasher.
• You must not produce flames under the
kitchen hood.
• Do not place anything on top of the cooker
hood.
• Disconnect the appliance before any
interior manipulation, e.g. during cleaning
or maintenance.
• We recommend the use of gloves and to
be extremely careful when cleaning the
kitchen hood's interior.
• Your kitchen hood is designed for domestic
use and only for extraction and purification
of fumes produced during food
preparation. It will be your responsibility if it
is used for other purposes, which may be
dangerous. The manufacturer cannot
accept responsibility for damage caused
by improper use of the appliance.
• For repairs please contact the nearest
KÜ ERSBUSCH Technical Assistance
Service, and always use genuine spare
parts. Repairs or modifications carried out
by unqualified personnel can cause
malfunctions or may damage the
appliance, putting your safety in danger.
• This appliance is marked according to the
European directive 2002/96/EC on “Waste
Electrical and Electronic Equipment”
(WEEE). This guideline is the frame of a
European-wide validity of return and
recycling on Waste Electrical and
Electronic Equipment, .
• This device is not meant to be used by
persons (including children) whose
physical, sensory or mental capacities are
reduced, or who lack experience/knowledge,
except if they have supervision or received
instructions for using the device by the
person responsible for his/her safety. Keep
children away from the device and never
let them play with it.
Safety Instructions

11
ENG
Index
age
Description of the appliance 11
Instructions for use 11
Cleaning and maintenance 12
roblem solving 12
Sizes and specifications 12
Accessories supplied 13
Installation 13
Active charcoal filters 13
AAn electronic programmer device with
TOUC CONTROL technology to control
speed, light, programming and power
indicators in use as well as filter saturation.
BMetal filters.
CLight.
You can activate or deactivate the cooker hood by
operating the functions shown in the diagram.
Switch on the extractor fan a few minutes before
you start to cook in order to ensure that a steady air
flow has been established before fumes appear.
Allow the extractor fan to run for several minutes
after you have finished cooking (between 3 to 5
minutes) in order to expel all the grease from the
outlet duct. This prevents the return of grease,
smoke and smells.
•Proceed as follows:
1)•Turn the kitchen hood on and choose the
required speed.
2)•Press "timer". Speed indicators 1, 2 and 3 will
start to flash.
3)•Choose the required time by pressing " + + + or
- - - ". There is a 10-minute interval between
each stage. Level 1 (minimum): 10 minutes;
level 3 (maximum):30 minutes.
4)•After having selected the working time, press
"timer" again to save the setting. The indicator of
the selected speed will start to flash.
5)•The kitchen hood will switch itself off after the
specified time.
•The maximum speed ‘ ’ can only be selected
manually and will be automatically changed to
the second speed level after approximately 10
minutes.
Clean the filters when the filter saturation
indicator lights up. (See page 12, filter cleaning).
•After cleaning the filters, and with the hood
turned off, simultaneously press " + + + and - - -
"for 3 seconds to switch off the indicator.
Description of the appliance
Instructions for use
Programming the timer
Filter saturation indicator “F”
Minimum speed
Medium speed
Maximum speed
Extra fan
Filter saturation ind.
Timer
Reduce speed
Increase speed
On-Off
Light

12
ENG
KÜ ERSBUSCH reserves the right to make changes and corrections to its products as it
deems necessary, without altering their basic characteristics.
During cleaning and maintenance work,
make sure the safety instructions set out
on page 10 are complied with.
• If your kitchen hood is made from stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• The use of vapour cleaners is not
recommended.
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Fig. 2
Proceed as follows:
• Unscrew the lamp cover.
• Change the broken/ burnt out lamp.
• Screw in the lamp cover back in.
Cleaning the metal filters
Cleaning the hood body
Cleaning an maintenance
_________________________________________________________
Problem solving
Proceed with the following checks before calling the Technical Service:
Changing light bulbs
Sizes an specifications
See page 22.
roblem ossible cause Solution
The kitchen hood does not
work.
The mains cable is not
connected to the network.
There is no current in the
network.
Connect the mains cable to the
network.
rovide current to the network.
The kitchen hood does not
extract sufficiently or
vibrates.
Filters are saturated with fat.
Obstruction in the air outlet.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
The lamps do not light up. The lamps are blown.
The lamps are slack.
Change the lamps.
Tighten the lamps.

4 Wall plugs (Ø8 x 40).
4 Long bolts (Ø5 x 45).
2 Wall plugs (Ø6 x 30).
2 Long bolts (Ø4 x 30).
2 Ø6,4 x Ø18, washers.
Fig. 1
On installing the kitchen hood make sure
that the Safety Instructions set out on page
10 are complied with.
To obtain optimum performance, the external
conduct must not be more than FOUR
METRES long, have no more than two 90°
angles and its diameter must be at least Ø120.
1) Mark and drill the points for fitting the wall
plugs onto the wall (P) (Ø8 x 40). See figure 1.
2) Place the wall plugs and screw the long
long bolts (Q) (Ø5 x 45) with the head of the
screw protruding 5 mm from the wall.
3) ang the cooker hood onto the long bolts
(Q). Level the unit and tighten the long bolts.
4) Mark the position of the wall plugs (R) (Ø8 x
40) through the inner side of the kitchen hood.
5) Loosen the long bolts (S) (Ø5 x 45) and
remove the hood. If your hood is made of
stainless steel, remove the plastic film before
mounting.
6) Drill the holes and put the wall plugs (R).
7) ang the hood, tighten the long bolts (Q)
and (S) (Ø5 x 45) with washers (T) (Ø6, 4 x
Ø18).
When exterior gas extraction is not possible,
then the kitchen hood may be set to purify the
air by recycling it through active charcoal
filters.
The active charcoal filters have an active life of
between three to six months, depending on the
individual conditions of use. These filters
cannot be washed nor regenerated. They must
be replaced once their useful life comes to an
end.
Active charcoal filters (Optional)
Installation
Accesories supplied
13
ENG

22
Código Técnico:************** F.Nr.**********
F-PTX

23
FIG.1