Operation Manual BP-1650
KAKA®Industrial
- 3 -
Safety
Authorized use
This bench hand break is designed for
bending metal and plastic materials
only.
The proper use also includes
compliance with the operating and
maintenance instructions given in this
manual.
The machine must be operated only by
persons familiar with it’s operation and
maintenance and who are familiar with
its hazards.
The required minimum age must be
observed.
The machine must only be used in a
technically perfect condition.
When working on the machine, all
safety mechanisms and covers must be
mounted.
Any other use exceeds authorization. In
the event of unauthorized use of the
machine, the manufacturer renounces
all liability and the responsibility is
transferred exclusively to the operator.
Safety notes
Metalworking machines can be
dangerous if not used properly.
Therefore, the appropriate general
technical rules as well as the following
notes must be observed.
Read and understand the entire
instruction manual before attempting
assembly or operation.
Keep this operating instruction close by
the machine, protected from dirt and
humidity, and pass it over to the new
owner if you part with the tool.
Install the machine so that there is
sufficient space for safe operation and
work piece handling.
Keep work area well lighted.
The machine is designed to operate in
closed rooms and must be bolted to the
cabinet stand or a solid work bench.
Keep the floor around the machine
clean and free of scrap material, oil and
grease.
Remove all loose clothing and confine
long hair.
Before operating the machine, remove
tie, rings, watches and other jewelry.
Wear safety shoes; never wear leisure
shoes or sandals.
Sheet metal stock has sharp edges.
WEAR GLOVES when handling sharp
edged work pieces.
WEAR SAFETY GLASSES.
