
5 USK ICBM 30116/30155 - 090716
OPERA ION
• After having unpacked the appliance, clean water tank and ice
ba ket thoroughly. Wait for 2 hours before taking the next step.
• Pour drinkable water in the water tank. Do not try to fill more than
50 Oz. water or above the level of the ice ba ket.
• To elect the ize of the ice cube , pre the SELECT button until
the corre ponding pilot light turn on. “S”: mall, or “L”: large.
• Pre START button to tart the ice making proce .
• If the water tank i getting empty, the “ADD WATER” pilot light will
turn on and a long beep will ound. In that ca e, the compressor
will stop automatically. Remove the ice ba ket, refill the water
tank. Wait for 3 mn after the beep ound before pre ing the
START button to re ume the ice making proce .
• When the “ICE FULL” pilot light witche on, a beep will ound; it
mean that you hould empty the ice ba ket. In that ca e, the
compre or will top automatically. Empty the ice ba ket
completely or partially. Wait for 3 mn after the beep ound before
pre ing the START button to re ume the ice making proce .
• You can top the ice making proce at any time by pre ing the
STOP button, to witch off the appliance.
• Do not leave the ice maker non working for a long period of time,
a the water could get tale and improper for con umption. If you
do, plea e refer to the “Cleaning and Care” ection of thi u er
manual.
NOTES:
If the ambient temperature i below 15°C/60°F, we advi e you
to elect the mall ize. If the ambient temperature i higher
than 29°C/85°F, we recommend you elect the large ize.
For be t performance, the temperature of the water you pour
into the water tank hould be between 7°C/45°F and
25°C/75°F and the ambient temperature between 15°C/60°F
and 37°F/100°F.
If you elect the large ize, the ice making proce will be a
little bit longer.
You must press “S AR ” button to restart the ice maker after
you add water or take out some of the ice after a warning
signal. If you do not, the compressor will automatically restart