Kambrook Frost Factory KIS20 User manual

2
Frost Factory
KIS20 Issue 1/05
GG
OO
OO
DD
NN
AA
MM
EE
GG
OO
OO
DD
VV
AA
LL
UU
EE

2
Kambrook Safety
Welcome to Kambrook and your new
Frost Factory.At Kambrook we believe
that the safe performance is the first
priority in any consumer product so that
you, our valued customer, can confidently
use and trust our appliances.We ask that
anyelectrical appliance that you use be
operated in a sensible fashion with due
care and attention placed on the following
important operating instructions:
IMPORTANT SAFEGUARDS FOR
YOUR KAMBROOK FROST
FACTORY
Carefully read all instructions before
operating the appliance and save for future
reference.
Remove any packaging material and
promotional stickers before using the
appliance for the first time.
Do not place the appliance near the edge
of a bench or table during operation.
Ensure the surface is level, clean and free
of water, etc.
Do not place this appliance on or near a
hot gas or electric burner, or where it
could touch a heated oven.
Handle the Ice chamber with care –
remember the blade assemblyis very
sharp and should be kept out of reach of
children.
Do not use attachments other than those
provided with the Frost Factory.
Do not attempt to operate the Frost
Factory by any method other than those
described in this booklet.
Do not operate the appliance with a heavy
load.
Do not run the motor without ice in the
ice chamber.
Always ensure the Frost Factory is
switched off at the power outlet and the
cord is unplugged from the power outlet.
Particularly when not in use, if left
unattended and when cleaning or storing.
Do not use the Frost Factory on metal
surfaces, for example, a sink drain board.
Do not use ice cubes made from ice cube
trays, automatic ice makers, bagged ice etc.
Only use the ice made from the freezer
containers supplied with this appliance.
Do not continuously run the motor for
more than 6 minutes at a time and rest
the appliance for 20 minutes before the
next operation.
Toprotect against electric shock do not
immerse the power cord, plug or motor
housing in water or anyother liquid.
Do not move the Frost Factory whilst in
operation.
Keep the appliance clean. Follow the
cleaning instructions provided in this
book.

3
IMPORTANT SAFEGUARDS FOR
ALL ELECTRICAL APPLIANCES
Unwind the cord before use.
Do not let the cord hand over the edge of
atable or counter, touch hot surfaces or
become knotted.
This appliance is not intended for use by
young children or infirm persons unless
they have been adequately supervised by a
responsible person to ensure that they
can use the appliance safely.Young children
should be supervised to ensure that they
do not play with the appliance.
It is recommended to regularly inspect the
appliance. Do not use the appliance if
power supply cord, plug or appliance
becomes damaged in any way. Return the
entire appliance to the nearest authorised
Kambrook Service Centre for examination
and/or repair.
Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.
This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use in
moving vehicles or boats. Do not use
outdoors.
The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.

4
KNOWYOUR KAMBROOK FROST FACTORY
1. Motor body
2. Ice chamber with shaving blade
3. Base
4. Freezer containers x 4
5. Push button to shaveice
4
5
3
2
1

5
Before first use
Remove all packaging material and
promotional labels. Wash the ice chamber
and base in warm, soapy water, rinse and
dry thoroughly.
Wipe the motor body with a damp cloth.
Assembling/Operating the
Frost Factory
Place water in the freezer container
leaving 1cm from the top to place the lid
on.Then place the container in the freezer
for 24 hours.
Place the motor body on a flat, dry
surface. Ensure the power plug is
unplugged from the power outlet.
Place a deep bowl or container onto the
base platform to hold shaved ice.
Place the ice chamber into the base by
lining up the flat sides and pushing the
chamber down.
Once the water in the freezer container
has set and formed into ice, remove the
freezer container from the freezer.
Removethe block of ice from the freezer
container.
Place the ice in the ice chamber.
Place the motor body on top of the ice
chamber. Plug the cord into a 230/240v
power outlet and switch on at the power
outlet.
Push the top of the motor housing to
start shaving. Release the motor housing
to stop shaving.
When ice shaving is complete, unplug the
Frost Factory and clean. Please see
Disassembling/Cleaning your Frost Factory
for directions.
NOTE! Please handle the ice chamber carefully
as the shaving blade is sharp. Mis-handling of the
blade may cause injury.
Tips for the best use of your
Kambrook Frost Factory
Do
Ensure all removable parts have been
thoroughly washed and dried before
assembly (except motor body).
Ensure the Frost Factory is correctly
assembled before operating.
Ensure the Frost Factory is used on
aclean, dry surface.
Don’t
Do not use ice cubes in the ice chamber.
Do not use the ice chamber to storeice.
Do not immerse the motor body, cord or
power plug in water or anyother liquid.
Do not use harsh abrasives or cleaners.
Do not place any of the removable parts
in the dishwasher.
Cleaning your Frost Factory
Ensure the Frost Factory has been
unplugged from the power outlet.
Remove the bowl of shaved ice from
the base platform.
Remove the motor body by lifting it in
an upwardposition. Do not immerse
in water.

6
Carefully remove the ice chamber by
lifting it in an upward position.
Some small ice pieces may remain in the
ice chamber; simply run the ice chamber
under warm water so that all excess ice
dissolves.
If extra cleaning is necessary, wash with
warm soapy water and dry thoroughly
with a clean cloth.
Do not use harsh abrasives or cleaners.
Dry all parts thoroughly.
Warning! Ice cubes must not be used
in the ice chamber. Only use the ice which
is formed in the freezer container.
NOTE! Do not place any of the removable parts
in the dishwasher.
NOTE! Do not immerse the motor base, cord
or power plug in water or any other liquid.
Cleaning the Motor Body
The Motor body can be cleaned with
asoft, damp cloth (do not use abrasive
agents or cloths which can damage the
surface). Dry and polish with a soft,
lint-free cloth.
Storage
Before storing, thoroughly wash and dry
all removable parts.
Assemble the Frost Factory and store on
the kitchen bench or in an easy to access
cupboard.
Storeout of reach of children.
Storethe appliance upright.
Do not store anything on top of
the appliance.

7
RECIPES:
FOR KIDS
Juicy treats
Add your favourite juice such as orange,
apple, pineapple or tropical to the shaved
ice.
Cordial treats
Add your favourite cordial to shaved ice
and enjoy the icy treat.You can also add
the cordial to the water before it is frozen
to create a coloured snow effect.
Soft drink flavourings:
Use soft drinks to enjoy a different
delicious icy flavour.
FOR ADULTS
Margarita
30ml Tequila
15ml fresh lime juice
30ml Triple sec or Cointreau
Shaved ice
Place all ingredients except ice into
cocktail shaker and shake it well. Place
shaved ice into glass with a salted rim.
Pour cocktail mixture over the shaved ice
and serve garnished with a lime slice.
Pina Colada
60ml pineapple juice
30ml coconut cream
30ml dark rum
Shaved ice
Place all ingredients except ice into
cocktail shaker and shake it well. Place
shaved ice into glass. Pour cocktail mixture
over the shaved ice and serve garnished
with pineapple leaves.
Fluffy duck
15ml white rum
15ml advocaat
60ml orange juice
15ml cream
Shaved ice
Place all ingredients except ice into
cocktail shaker and shake it well. Place
shaved ice into glass. Pour cocktail mixture
over the shaved ice and serve garnished
with a twisted orange slice.
Splice
30ml Midori
30ml Malibu
60ml pineapple juice
40ml cream
Shaved ice
Place all ingredients except ice into
cocktail shaker and shakeit well. Place
shaved ice into glass. Pour cocktail mixture
over the shaved ice and serve garnished
with a slice of pineapple and a cocktail
cherry.
Tip! Always refill the empty freezer containerswith
water and place in freezer, ready for next use.

8
Notes

9
Notes

10
Notes