K&B Furniture D510-T User manual

NOTE TO CUSTOMERS:
For ease and speed of assembly we recommend that before you commence each step of the
assembly that you identify all the parts required to complete that step.
We recommend that where possible you allow sufficient space to assemble the item as close
as possible to the place where it will be once assembled.
For the protection of your furniture we recommend that the product is placed on protected
surfaces during assembly to prevent any damage.
During assembly do not over tighten the screws or bolts, as this may damage the product.
Please ensure you retain all the product packaging until the item is completely assembled.
Periodically check all fitting and re-tighten as necessary.
Never allow any liquids to remain on your furniture as absorption can cause the wood to warp
or finish to de-laminate.
It is recommended that this item should be assembled by two adults.
ASSEMBLY INSTRUCTIONS
MODEL # D510-T DINING TABLE
PAGE 1 OF 2

PAGE 2 OF 2
ASSEMBLY INSTRUCTIONS ITEM # D510-T DINING TABLE
PARTS IDENTIFICATION
A- Table Top 1 pc
B- Leg Panel (Long) 2 pcs
C - Leg Panel (Short) 2 pc
HARDWARE IDENTIFICATION
1- Minifix Connecting Bolt 12 pcs
2- Minifix Connector Housing 12 pcs
3- Screws 14 pcs
4- Metal L-Bracket 8 pcs
5- Screws 32 pcs
NOTE: Quantities shown are for one table.
1 1/8”
Ø4mm
Insert & tighten bolts into
the holes in (B) panel. Insert connector into the pre-drilled holes in (C) panel.
Lock each connector to
secure the bolts tight.
STEP 1 STEP 2
MARKING LINES
Place Table top upside down. Place the table base within the marked lines on
the table top.
Use screws (3) to attach table base to table top. Make sure all screws and
connecting bolts are fully tightened before turning the table upright.
1/2”
Ø4mm
MARKING LINES
Place the Metal L-Bracket
within the marked lines on
the leg panels and use screw
(5) to attach the brackets so
that to secure the leg panels
assembly.
4
5