Figure 1
Figure 2
IMPORTANT
1. Please read the instruction manual carefully
before operate the rechargeable fan unit.
2. Make sure the electric rating of your home
AC power supply before plugging in.
3. Please keep always recharging when light
goes dim or recharge the fan when power
low.
4. Make sure the appliance switchs must be
in "OFF" position when not in use.
5. The efficiency may decrease if used or
(Light goes dim & power low of battery
recharged) when temperature are below
32˚F (0˚C) or above 104˚F (40˚C).
6. Please keep out of reach of water or rain
for properly use.
RECHARGEABLE FAN WITH HIGH-LOW
SPEED
1. Place the fan High-Low Speed Press (No.7)
in “HIGH” or press (No.6) “LOW” speed
position to start the fan with high or low
speed.
2. Pace the Press to "OFF" position to end the
operation.
3. To adjust the fan cover speed, turn the Fan
Cover Speed Adjust Knob (No.4) to adjust
the desired speed level. (FIGURE 1)
LED LIGHT OF OPERATION
Place the LED light ON/OFF switch (No.8) in
"ON" position, the LED will light up immediately.
Push to "OFF" position to end the operation.
HOW TO REPLACE THE RECHARGEABLE
BATTERY (FIGURE 2)
1. Release the battery cover screw (No.11)
and open the battery cover.
2. Replace with new rechargeable battery
and reassemble in reverse procedures.
WARNING: PLEASE DO NOT SHORT CIRCUITS
WITH BATTERY CONTACT (+) & (-) OR PUT INTO
FIRE. DO NOT USE OTHER THAN SPECIFIED
BATTERIES FOR THIS RECHARGEABLE FAN EXCEPT
ORIGINAL DESIGNED BATTERY.
Note: Each unit contains one or two batteries.
(optional)
HOW TO RECHARGE THE BATTERY
Note : Before recharging, please make sure
all the switches must be in “OFF” position.
1. Open the battery cover (No.10)and pull
out the (AC or DC Adaptor) then plugging
in AC power supply (wall socket).
2. Red charging indicator (No.9) lights up
shows the rechargeable fan unit is under
charging.
3. Normal charging time for maximum is
approximately 12 hours.
4. The battery became slightly warm during
charging, this is normal.
WARNING FOR THE RECHARGEABLE LEAD
ACID BATTERY.
1.
This Rechargeable Lantern is only applicable
for charging the sealed Lead-Acid battery.
Do not charge with different types or non-
rechargeable batteries.
2. During using or recharging the lead-acid
battery, the appliance
must be placed in a well
ventilated area.
3. The orientation of the
lead-acid battery with
regard to polarity battery
contact(+)& (-). Do not short circuit or put
into fire, avoid reverse charging.
4. Regarding safe disposal of used lead-acid
batteries, insert the batteries into battery
charger according to the lead-acid battery
polarity. After use, charge the lead-acid
battery at least 20 hours every time to
achieve full charge condition.
5. Leaking lead-acid battery must be removed
from the appliance carefully. The lead-acid
battery must be recycled or disposed of
properly.
6 The lead-acid battery must be removed
from the appliance before it is scrapped.
7 The lead-acid battery is to be disposed of
safely by putting into battery compartment
with cover.
8 The appliance must be disconnected from
power supply before removing the battery.
TECHNICAL SPECIFICATIONS
Input voltage.........................................DC12V
Input Maximum Power..............................24W
Operating Temperature...................0°C-40°C
Humidity ..................................lower than 90%
Battery Spec........................................... DC6V
Fan Motor............................................... DC6V
Charging Time............12 Hours for "1 battery"
Duration Time:
Fan (High Speed)....................apprx 2.5 Hours
Fan (Low Speed)....................apprx 3.5 Hours
LED Light...................................apprx 40 Hours
(
If using "2 Battery" will be double of duration time
)
Light Specification:
SMD LED Light x 10 pcs
MAINTENANCE
Use a small cotton swab with cleaning alcohol
to clean the plastics. Never use strong or
volatile chemicals.
WARNING:
A. To avoid an electrical shock, please do not open
the rear cabinet (rechargeable fan) for repair or
cleanning unless qualified person.
B.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a
hazard.
C.
The appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience andd
knowledge, unless they have been given
supervision
or instruction concerning use of the
appliance by a person responsible for their safety.
D.
Children should be supervised to ensure that they
do not play with the appliance.
IB399DA08-RH
