3
REV.1.10.13
This equipment package contains the
following:
1. Main Channel and Ram Assembly
2. Short Channel Assembly
3. 3-Point Hitch Mount/Stabilizer
Assembly
4. Manual Tilt Base Plate Assembly
5. Hydraulic Valve Assembly
6. Hydraulic Hose and Adapter Kit
7. Debris Guard
8. Post Holder Assembly
Kencove Farm Fence Supplies recommends
for best life and service of this equipment that
it is always stored in a clean, dry, and secure
location. Life and service of this equipment
will be shortened if not protected from the
elements.
WARNING! The driver must be
secured to the machine on which it
will be operated by, or secured to an
adequate object to prevent the unit from
tipping. Serious injury, death, and/or
property damage may be a result from not
securing unit.
WARNING! Personal protective
equipment should be worn during
cleaning. This includes, but not be limited
to, safety glasses, hearing protection,
protective gloves, and steel toe footwear.
Storage
1. Clean before storing:
Remove loose debris.
Clean the entire driver:
Compressed air or
pressure washer.
2. Inspection of the Driver:
Road lock pin should be in the
top hole of ram I-beam for
storage.
Ensure all bolts are tight.
Check that correct pins are
secured in the correct location.
Verify all warning labels are in
their correct location and are
readable.
Inspect complete hydraulic
system for leaks or signs of
wear.
Place debris guard in correct
position and check that it is in
working condition.
Move valve control lever to
check full range of motion and
that the lever lock is operating
correctly.
3. Replace any worn or damaged parts
before operating this equipment.
4. Lightly coat four (4) guide blocks with
new oil. Do not use grease, grease can
hold contaminates that will put
excessive wear on guide blocks.
5. To prevent rust, coat exposed hydraulic
cylinder shaft with a thin layer of new
grease.
Note: Inspection steps of driver should be
followed before each time equipment is
stored, and before every use of the Driver.
