Kendall Howard 1906-3-007-01 Manual

Assembly - Step 4:
4
DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com-
plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
relia n ce placed on the information is therefo re strictly at your own risk.
For details about product warranty, please visit www.kendallhoward.com
Keep in mind that, as with all shelving, the
weight capacity is directly related to the style
and quality of hardware and rail you use.
Shelving units that are extended to their longest
position will experience a significant reduction in
weight capacity. The rule of thumb is, the
shorter the shelf span, the stronger the shelf.
When adding components onto the shelf, try to
keep them spaced so the weight is distributed
evenly.
Instructions / Directions
Four (4) Point Adjustable Shelf
# 1906-3-007-01 (1U Solid)
# 1906-3-006-02 (2U Solid)
# 1906-3-008-01 (1U Vented)
1
INNO VATOR S IN PRO DUCT DES IGN
w w w . k e n d a l l h o w a r d . c o m
A d d r e s s : 1 0 1 5 2 L i b e r t y L a n e
C h i s a g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i t e d S t a t e s o f A m e r i c a
Phone: [phone]
F a x : 800-418-6897

Tools Needed:
Included:
2
Screw Driver
(1x) Base Shelf
(Has Round Side Holes)
(8x) 10-32 Screw (8x) 10-32 Nut
Assembly - Step 1:
Attach Base Shelf to front rails using correct fasteners for
your type of rack rails.
Wrench 3/8in
(1x) Extension Shelf
(Has Slotted Side Holes)
Assembly - Step 2:
Assembly - Step 3:
3
Place the Extension Shelf inside the Base Shelf with the
mounting ears adjacent to the back rails and attach using
the correct fastener for your type of rack rails.
Bolt shelves together through the closest aligning slot and round
hole to each rail with hardware provided. The further apart the
bolts are from each other, the stronger the shelf will be.