Kendall Howard 1915-3-300-21 Manual

4
Assembly - Step 3:
DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com-
plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
relia n ce placed on the information is therefo re strictly at your own risk.
For details about product warranty, please visit www.kendallhoward.com
Mount rack to wall using appropriate hardware
(not included). Fasten to secure surfaces such as
wall studs to increase weight capacity.
Instructions / Directions
V-Line Wall-Mount Rack 21U
#1915-3-300-21
1
INNO VATOR S IN PRO DUCT DES IGN
w w w . k e n d a l l h o w a r d . c o m
A d d r e s s : 1 0 1 5 2 L i b e r t y L a n e
C h i s a g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i t e d S t a t e s o f A m e r i c a
Phone: [phone]
F a x : 800-418-6897

Tools Needed:
Included:
2
Screw Driver
(2x) H-Brace
(2x) Side Rail
(4x) Corner Bracket
(24x) Rack Screw
(16x) 10-32 Screw
(24x) Cage Nut
Assembly - Step 1:
Assembly - Step 2:
3
Lay Side Rails face down. Align H-Braces at both ends
and Corner Brackets on the outside at each corner.
Use the supplied 10-32 Screws to fasten the rack together.
Use a Screw Driver to secure all of the screws.
*Note: Rack comes in several sizes, but assemble and install in the same way.