Kendall Howard 5500-3-100-02 Manual

4
DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com-
plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
relia n ce placed on the information is therefo re strictly at your own risk.
For details about product warranty, please visit www.kendallhoward.com
Instructions / Directions
Training Table Keyboard Tray / Drawer
# 5500-3-100-02
1
INNOVAT ORS IN PRODU CT D ES IGN
w w w . k e n d a l l h o w a r d . c o m
A d d r e s s : 1 0 1 5 2 L i b e r t y L a n e
C h i s a g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i t e d S t a t e s o f A m e r i c a
Phone: [phone]
F a x : 800-418-6897

Tools Needed:
2
Screw Driver
(4x) 1/4-20 Screws
a. Line up keyboard tray brackets/slides with the pre-drilled
holes in the table top surface
b. Make sure the notch in the slide rails is facing the rear of the
table
Included:
Notch to the REAR
Assembly - Step 1:
(2) Bracket/Slides
Assembly - Step 2:
3
a. Secure with included 1/4” screws
Assembly - Step 3:
a. Insert Keyboard Tray into mounted slides.
To utilize as a Keyboard Tray insert with hollow area facing down
To utilize as a Pencil Drawer insert with hollow area facing up