Kennedy Versa-Bench 4810 Installation guide

®
TOOLBOXES
CHESTS/CABINETS
WORK STATIONS
MODULAR CABINETS
Kennedy Manufacturing Company
520 E. Sycamore Street • Van Wert, OH 45891
Phone [phone] • FAX [phone]
www.kennedymfg. com
Versa-Bench Model 4810 Assembly Instructions
Style No. 4810
Part No. 527052, Rev. 7/05
BEFORE ASSEMBLY OF YOUR VERSA-BENCH®
Check carefully to ensure that all parts listed on the reverse side are included. If any are missing,
please call 800-413-8665 and ask for the Sales Dept. Do not discard packing material until assembly
is complete.
TOOLS REQUIRED
Flat tip screw driver
7/16” Open end wrench or socket wrench
3/8” Open end or socket wrench

A
B
C
E
F
D
H
G
QTY KEY PARTS DESCRIPTION
1 (A) Chrome Plated Push Handle
4 (B) 1/4” x 3/4” Hex Head Bolts
2 (C) 8” x 2” Swivel Casters
2 (D) 8” x 2” Rigid Casters
1 (E) Floor Lock
20 (F) 3/8” x 3/4” Hex Head Bolts
2 (G) “L” Shaped Aluminum Door Handle
4 (H) #8-18 x 3/8” Sheet Metal Hex Screws
1. Fasten chrome push handle (A) to end of bench as shown using (4) 1/4” x 3/4” hex head bolts (B).
2. Lift bench with a fork lift or lay on its back on shipping carton to install casters and floor lock.
Remove bolts from wood shipping blocks from bottom of the Versa-Bench.
3. Fasten swivel casters (C), floor lock (E) and at opposite end attach rigid casters (D) with (4) each
3/8” x 3/4” hex bolts (F) to weld nuts in bottom. Carefully, set bench upright. Note: Swivel casters
and floor lock should be located at same end of bench as chrome push handle.
4. Fasten door handles (G) to each door with (4) 3/8” sheet setal hex screws (H).