C-V751
4
CIRCUIT DESCRIPTION
Pin No. Pin Name I/O Description ACTIVE
HL
1 AMUTE O Audio muting control. Mute:ON Mute:OFF
2 POWER O Power ON/OFF relay control. Power:ON Power:OFF
3 POWER O Power amplifier relay control. Power:ON Power:OFF
4 F RLY O Front speaker relay control. Relay:ON Relay:OFF
5 C RLY O Relay control of center,surround and SW woofer. Relay:ON Relay:OFF
6 S RLY O Rear speaker relay control. Mute:ON Mute:OFF
7 +3dB O +3dB attenuation control for super woofer. ATT:ON ATT:OFF
8 20dB O +20dB attenuation control for volume control. 20dB gain
9 PROTECTION I Detection terminal of protection signal. PRT:ON
10 S DATA I/O Serial communication data signal.
11 S BUSY I/O Serial communication busy signal.
12 T MUTE O Muting control of audio signal for tuner. Mute:ON Mute:OFF
13 PLL CLK O Clock output of PLL IC for tuner.
14 PLL DATA O Data output of PLL IC for tuner.
15 PLL CE O Chip enable of PLL IC for tuner.
16 PLL DO I Data input from PLL IC.
17 SD I Syntony signal input of tuner.
18 STEREO I Stereo signal input.
19~22 T SW1~4 I Discrimination of the tuner destination.
23 M OPEN O Control terminal of motor driver.(Motor CW îDoor open)
24 M CLOSE O Control terminal of motor driver.(Motor CCW îDoor close)
25 OPEN SW I Detection port of door open/close switch. Open
26 CLOSE SW I Detection port of door open/close switch. Close
27 DIG. H O Port for digital input.
28 RWR I Reading of interactive remote control data.
H:End of reading data.
29 ENB I Permission of transmission . Permission
30 REQ O Request of transmission. No Request
31~38 R DATA1~8 O Data output to remote control microprocessor.
39 CE I Chip enable.
40 RST I Reset signal input.
41 VSS - Ground.
42 XTAL - 16MHz main oscillator.
43 EXTAL I 16MHz main oscillator.
44 SEL STB2 O Unused.
45 SEL STB1 O Strobe output to selector IC.
46 SELCLK O Clock output to selector IC.
47 SEL DT O Data output to selector IC.
48~50 VIDEO1~3 O Control port for video selector.
51 DSP RST2 O Reset signal output to DSP.
52 AVSS - Ground.
53 AVREF - Connected to VCC.
54 AVDD - Power supply(+5.0V).
55 VOL CLK O Clock output to electric volume(IC28).
56 VOL DATA O Data output to electric volume(IC28).
57 VOL LATCH O Latch output to electric volume(IC28).
58 CODEC RST O Reset port to A/D,D/A converter.
59 - - Unused.
60 RDS SLEVEL I Signal level input from RDS decoder.
61 DOOR KEY I Detection port of door key(S16) .
62 POW KEY I Detection port of power key(S3).
63 OESL O Switching the output enable.
64 AUDIO I Detection port of audio.
4. Microprocessor: CXP740010-107Q(X08,IC16)
4-1 Port description of microprocessor