Kenwood CM650 series User manual

to make coffee
1Pour water into the tank. The
water must be between the top
and bottom cup marks. Then close
the lid.
●Use cold water. We recommend
using filtered water from a
Kenwood Water Filter as it reduces
limescale. Never use warm or fizzy
water.
●If you use the jug to fill the tank,
look at the tank marks, not the jug
marks. They’re slightly different to
allow for the fact that some of the
water gets absorbed by the coffee.
2Open the filter door by pressing
the release button and insert the
filter holder.
3Add either a permanent filter or a
paper filter. Add the coffee
(approximately 1 rounded
dessertspoon/7g per cup). Then
close the filter door.
4Put the jug on the hotplate.
5Plug in and switch on.
●Model CM660 press the
auto/on/off button twice. The
light will come on.
6CM660: to produce stronger
coffee press the strength control
button.
●During operation the strength
control indicator light will glow for
approximately 10 minutes.
7Don’t remove the jug until brewing
has finished. The hotplate will keep
your coffee hot, but the sooner you
drink it, the better it will taste.
●Model CM660 After 2 hours,
power to the hotplate will cease
and the auto/on/off indicator light
will go out.
8When the jug’s empty, switch off
by pressing the on/off switch
(CM650) or the auto/on/off button
(CM660). Let the machine cool
down before cleaning.
●If you haven’t used the machine for
a while, run one lot of water
through it (without coffee) to clean
it out. Fill the tank to the top cup
mark when you do this.
●Never put the jug in the
microwave.
to use the automatic timer
(model CM660 only)
1Set the correct time.
2Press the automatic timer button
and at the same time adjust the
Hour and Minute buttons to
display the time you want the
coffee maker to come into
operation. Make sure that the
desired AM or PM is selected.
3Release the automatic timer
button.
4Press the auto/on/off button once.
The automatic timer light will glow.
●When the set brewing time is
reached the coffee maker will
operate, the automatic timer light
will go out and the auto/on/off light
will come on.
care & cleaning
●Always switch off and unplug
before cleaning.
●Never put the machine in water or
let the cord or plug get wet.
jug, lid, filter holder,
permanent filter
●Wash, then dry.
body, filter door
●Wipe with a damp cloth, then dry.
Don’t use abrasives - they’ll
scratch the plastic.
descaling
You’ll know when limescale has
built up because your coffee will
take longer to come through.
When this happens it’s time to
descale.
safety
●Never let the cord hang down over
the worktop edge - a child could
grab it and pull the machine down.
Push excess cord inside the back
of the machine.
●Always make sure there is water in
the tank before switching on.
●Never use a damaged coffee
maker. Get it checked or repaired:
See ‘service and customer care’.
●Never put the machine in water or
let the cord or plug get wet.
●Watch out for steam and never
touch the hotplate.
●This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use of
the appliance by a person
responsible for their safety.
●Children should be supervised to
ensure that they do not play with
the appliance.
●Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper
use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
Important (UK) only
●The wires in the cord are coloured
as follows:
Green and Yellow = Earth
Blue = Neutral
Brown = Live.
●This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first
time
1Remove all packaging.
2Wash the parts: see ‘care and
cleaning’.
3. Push excess cord inside the back
of the machine.
4. Run two lots of water through the
machine (without coffee) to clean it
out. Fill the tank to the top cup
mark when you do this. See ‘to
make coffee’.
key
hotplate
compartment for excess cord
filter door release button
permanent coffee filter (or use a
paper filter instead)
filter holder
filter door
on/off switch with indicator light
(model CM650 only)
additional features on the
CM660
strength control indicator light
strength control button
auto/on/off indicator light
auto/on/off button
automatic timer light
automatic timer button
hour button
minute button
to set the clock (model
CM660 only)
(the clock does not have to be set
in order for the coffee maker to
operate)
1Plug into the power supply.
2Press the hour and minute buttons
until the correct time is shown.
Make sure when selecting the hour
that AM or PM is correctly
selected.
●Providing the appliance remains
connected to the power supply the
clock will keep the correct time, if it
is unplugged the clock will flash
12:00.















CM650
CM660

Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK
www.kenwoodworld.com 10142/3
CM650 series
CM660 series
to descale
1Buy a suitable descaler.
2Descale the machine.
3After descaling, run several lots of
water through the machine to
clean it out. Fill the tank to the top
cup mark when you do this.
4Wash the parts.
service and customer
care
●If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised
Kenwood repairer.
UK
If you need help with:
●using your machine or
●servicing, spare parts or repairs (in
or out of guarantee)
call Kenwood customer care on
023 92392333. Have your
model number ready - it’s on
the underside of the coffee maker.
For spare parts including water
filters call 0870 241 3653.
●other countries
Contact the shop where you
bought your machine.
guarantee
If your coffee maker goes wrong
within one year from the date you
bought it, we will repair it (or
replace it if necessary) free of
charge provided:
●you have not misused, neglected
or damaged it;
●it has not been modified (unless by
Kenwood);
●it is not second-hand;
●it has not been used
commercially;
●you have not fitted a plug
incorrectly; and
●you supply your receipt to
show when you bought it.
This guarantee does not affect
your statutory rights.