before using your Kenwood
appliance
●Read these instructions carefully
and retain for future reference.
●Remove all packaging and any
labels.
safety
●Your kettle as a dual voltage
selector on t e underside
of t e kettle. Always c eck
t at you ave selected t e
correct voltage before using
t e kettle.
●Always use the filter and never
overfill - boiling water may splash
out.
●Avoid contact with steam coming
out of the spout area when pouring
and out of the lid or spout area
when refilling.
●Never let the cord hang down
where a child could grab it.
●Always unplug your kettle
w en not in use.
●Never put the kettle, cord or plug in
liquid.
●Never use a damaged appliance.
Get it checked or repaired: see
‘service and customer care’.
●Caution: Do not operate the kettle
on an inclined surface.
●Make sure the lid is secure before
switching the kettle on.
●Warning: Do not open the lid while
the water is boiling.
●Take care when opening the lid -
droplets of hot water may be
ejected.
●Make sure the kettle is switched off
before lifting or pouring.
●Unplug the kettle before filling or
pouring.
●Never put the kettle near or on
cooker hot plates or gas burners.
●This kettle is for boiling water only.
●This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●Children should be supervised to
ensure that they do not play with
the appliance.
●Only use the appliance for its intended
domestic use. Kenwood will not
accept any liability if the appliance is
subject to improper use, or failure to
comply with these instructions.
before plugging in
●Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
The JKP250 travel kettle is of class
1 construction and should only be
used in an EARTHED socket. Any
travel plug adapter used MUST
provide an earth connection.
Important - UK only
●The wires in the cord are coloured
as follows:
Green and Yellow Earth
Blue Neutral
Brown Live.
●The appliance must be protected
by a 13A approved (BS1362) fuse.
●WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
●For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
●This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for t e first
time
●Remove the cups and spoons from
the kettle.
●Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
●Wash the cups and spoons and
then dry.
key
hinged lid
lid release catch
on/off switch
indicator light
water level windows
cord clip
filter
2 cups
2 spoons
dual voltage selector
to use your travel jug
kettle
1 Remove the cups and spoons from
the kettle.
2 Select the required voltage by
turning the selector control .
Always c eck t at you ave
selected t e correct voltage
before using t e kettle.
3 Fill the kettle through either the
spout or lid. To open the lid, pull
back the lid release catch . The
water level must be between
‘MAX’ and 1 cup (200mls).
●Be economical: do not boil more
water than you need.
●To improve the quality of your
drinks always use fresh water.
●Empty the kettle after each use.
4 Check the lid is closed.
5 Plug in and switch on. The
indicator light will come on.
6 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
●If you experience problems
wit your kettle switc ing on
and off during use or
switc ing off before boiling,
ceck t at t e flat element
is free from scale - see
“descaling”.
●Take care when using the cups
and do not overfill above the inner
rim (approx. 200mls).
●Your kettle is fitted with a filter to
hold back limescale particles.
●If you find drops of water under
your kettle, don’t worry - it is just
condensation.
boil-dry protection
●If you switch on with too little
water, your kettle will cut out
automatically. Switch off, unplug
and let it cool down before re-
filling. When it has cooled down,
the switch will reset itself.
care and cleaning
●Before cleaning, unplug your kettle
and let it cool down.
●The cups and spoons can be
placed in the kettle for compact
storage.
●Wrap the cord around the kettle
and secure using the cord clip .
t e outside
●Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the plastic surfaces.
t e inside
●Even though your kettle comes
with a filter, you still need to clean
the inside (and the filter) regularly.
t e filter
1 To open the lid, pull back the lid
release catch .
2 Unclip and slide out the filter .
3eit er rinse under the tap or use
a soft brush.
or when descaling your kettle,
drop the filter in too. Rinse
thoroughly.
4 Replace the filter by locating the
front of the filter into the spout area
and then clip into place .
