
English
5
lRinse out with fresh water if the
kettle has not been used for
more than 2 days.
lNote - To interrupt the boiling
ensure that the switch is in the
off position before removing
from the powerbase.
lYour kettle is fitted with a filter
to hold back limescale particles.
Boil-dry protection
lIf you switch on with too little
water, your kettle will cut
out automatically. Switch off,
remove from the powerbase
and let it cool down before
re-filling. When it has cooled
down, the switch will reset itself.
Care and Cleaning
Refer to Illustrations
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z
-
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z
lBefore cleaning, unplug your
kettle and let it cool down.
The outside and powerbase
lWipe with a damp cloth, then
dry. Do not use abrasives -
they will scratch the metal and
plastic surfaces.
The inside
lWipe with bicarbonate of
soda on a damp cloth. Rinse
thoroughly.
lEven though your kettle comes
with a filter, you still need to
clean the inside (and the filter)
regularly.
The filter
Refer to Illustrations
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z
-
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z
1 Remove the lid.
2 Unclip and slide out the filter.
3 Either rinse under the tap
or use a soft brush or when
descaling your kettle, drop the
filter in too. Rinse thoroughly.
4 Replace the filter into the spout
area then clip into place.
Descaling
lRegular descaling of the flat
element will improve the
performance of your kettle.
If the kettle is not descaled
regularly the build up of
limescale may result in the
following:
lproblems may be
experienced with the kettle
switching on and off during
use or switching off before
boiling.
lthe kettle may take longer to
boil.
lthe flat element may be
damaged.
Please note: Failure to descale
your kettle may invalidate your
guarantee.
lWhen limescale starts to build
up on the heating element, buy
a suitable descaler and descale
your kettle. After descaling, boil
with fresh water several times
and discard. Clean any descaler
off the kettle - it can damage
the parts.
lSome regions of the country
have chalky water. This makes
boiled water look cloudy and
leaves a deposit on the side of
the kettle. This is normal but
can be removed with regular
cleaning.
lAlternatively, to reduce
limescale build up, use filtered
water to fill your kettle.