Kenwood NEXEDGE NX-700H User manual

DIGITAL – COMMON
• NXDN®Digital Air Interface
• A BE+2™VOCODER
• 6.25 & 12.5 kHz Channels
• Over-the- Air Alias
• Paging Call
• Emergency Call
• All Group Call
• Status essaging1
• Remote Stun/Kill1
• Remote Check1
• Short & Long Data essages1
• GPS Location with Voice1
• NXDN®Scrambler Included (Conventional: per CH)
DIGITAL CONVENTIONAL MODE
•64 Radio Access Numbers (RAN)
•DT F (Encode/Decode)
•Individual & Group Selective Call
•ixed F /Digital Operation
DIGITAL TRUNKING MODE
•Individual Private Call
•Group Call
•Broadcast Call
•Transmission Trunked ode2
•essage Trunked ode2
•Call Queuing with Priority2
•Call Queue Pre-emption2
•Late Entry (UID & GID)2
•4 Priority onitor ID’s2
•Remote Group Add1
•Failsoft ode
•ulti-Site IP Network Compatible
SCAN
•Single Zone / ulti-Zone / List Scan
•Dual Priority Scan (Conventional)
FM MODES - GENERAL
•25 & 12.5 kHz Channels
•FleetSync®/II
•DT F Encode/Decode
•Companded Audio
•Voice Inversion Scrambler
•Encryption/ANI Board Control
FM CONVENTIONAL ZONES
•QT / DQT
•Two-Tone Decode
•Single/Two-Tone Encode
•Call Key 1-6
•Operator Selectable Tone
FM LTR®TRUNKED ZONES
•Kenwood LTR®Features
FleetSync®/II (FM)
•PTT ID Digital ANI
•Selective Call & Group Call
•Status essaging1
•Emergency Status
•Caller ID Display
•Short Text essages1
•Power On/Off Status essages1
•Input/Output Status essages1
•Send/Display GPS1
•PTT ID & Emergency GPS Reporting1
•Status essage Block GPS Reporting1
•Ignition On/Off GPS Reporting1
GENERAL FEATURES
• 30W / 50W (136-174 Hz) odels
• 30W / 45W (400-470, 450-520 Hz) odels
• 512 CH-GID / 128 Zones
• Dash & Remote ount
• 14 Character Alphanumeric Aliases
• Backlit Dot atrix LCD
• 3-Digit Sub-Display
• Function/Status LCD Icons
• RSSI Indicator
• Date & 12/24 Hour Time Clock
• Transmit/Busy/Call Alert/Warn LED
• On/Off Power Control
• 4 Up/Down Selectors
• 6 Front PF Keys
• Emergency/AUX Key
• 4W Speaker Audio
• Emergency Call Features
• Lone Worker
• ulti-Language Display
• Programmable TX/RX Indication (On/Off)
• Special Alert Tone Patterns
• Time Out Timer
• Busy Channel Lockout
• DB-25 Accessory Connector
• 9 Programmable AUX I/Os
• 2 Programmable AUX Outputs
• Ignition Sense
• Public Address / Horn Alert Option
• IL-Spec Standard ic
• IL-Spec 12-Key DT F ic Option
• KPG-111D Windows®FPU
• Flash Firmware Upgrading
• Front Panel Test & Tune
• Cloning
• IL-STD-810 C/D/E/F
• IL-STD “Driven-Rain”
• IP-54/55 Water & Dust Intrusion
• Easy Option Port
• PC Serial Interface
• SD anual Input1
• Transparent Data ode1
• GPS Receiver Option
• VGS-1 Voice Guide / Voice & GPS Data
Storage Option
NX-700(H)/800(H)
NEXEDGE™VHF/UHF Digital & FM Mo ile Radios
http://nexedge.kenwood.com

All accessories and options may not be available in all markets.
Contact an authorized Kenwood dealer for details and complete list of all accessories and options.
Options
NX-700(H) K NX-800(H) K
GENE AL
Frequency ange Type 1 136-174 MHz 450-520 MHz
Type 2 400-470 MHz
Number of Channels 512
Zones 128
Max. Channels per Zone 250
Channel Spacing Analog
12.5 / 15 / 25 / 30 kHz
12.5 / 25 kHz
Digital 6.25 / 12.5 kHz 6.25 / 12.5 kHz
Operating Voltage 13.6 V DC ± 15%
Operating Temperature ange -22˚ F to +140˚ F (-30˚ C to +60˚ C)
Frequency Stability ± 1.0 ppm
Antenna Impedance 50 Ω
Dimensions (W x H x D)
Projections not included
6.30 x 1.77 x 6.18 in (160 x 45 x 157 mm)
Weight (net) 3.04 lb (1.38 kg)
FCC ID K Type 1 K44378600 K44378700
K Type 2 K44378701
HK Type 1 K44378601 K44378702
HK Type 2 K44378703
IC Certification K Type 1 282F-378600 282F-378700
K Type 2 282F-378701
HK Type1 282F-378601 282F-378702
HK Type 2 282F-378703
NX-700(H) K NX-800(H) K
ECEIVE
Sensitivity Digital @ 6.25 kHz (3% BE ) 0.20 µV
Digital @ 12.5 kHz (3% BE ) 0.28 µV
Analog (12 dB SINAD) 0.25 µV
Selectivity Analog @ 25 kHz 80 dB
Analog @ 12.5 kHz 70 dB
Intermodulation Analog 75 dB (±50,100 kHz)
Spurious esponse Analog 90 dB 85 dB
Audio Distortion Less than 3%
Audio Output 4 W / 4 Ω
T ANSMITTE
F Power Output Mid Power 30 W to 1 W 30 W to 1 W
25 W to 1 W (490-520 MHz)
High Power 50 W to 10 W 45 W to 10 W
40 W to 10 W (490-512 MHz)
35 W to 10 W (512-520 MHz)
Spurious esponse 73 dB 75 dB
FM Hum & Noise Analog @ 25 kHz 50 dB
Analog @ 12.5 kHz 45 dB
Audio Distortion Less than 3%
Modulation 16K0F3E, 14K4F1D, 11K0F3E, 8K30F1E,
8K30F1D, 8K30F7W, 4K00F1E,
4K00F1D, 4K00F7W, 4K00F2D
MIL Standard MIL 810C MIL 810D MIL 810E MIL 810F
Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II
Solar adiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I
ain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I
Shock 516.2/Procedure I, II, III, V 516.3/Procedure I, IV, V 516.4/Procedure I, IV, V 516.5/Procedure I, IV, V
International Protection Standard
Dust & Water Protection IP54: adio itself
IP54/55:
emote head with K K-10
Main Specifications
Applicable MIL-STD & IP
■KMC-35
Microphone
■KMC-36
Microphone
with Keypad
■KMC-9C
Control Station
Desktop Microphone
■KES-5
External Speaker
■VGS-1
Voice Guide
& Storage nit
■KRK-10
Panel Remote Kit
■KPS-15
DC Power Supply
■KAP-2
Horn Alert
/ PA Relay nit
■KCT-23M
DC Cable (10 feet)
■KCT-23M3
DC Cable (23 feet)
■KCT-46
Ignition Sense Cable
■KMB-10
Key Lock Adapter
■KLF-2
Line Noise Filter
KCT-23M3
ADS#11409 Printed in SA
Kenwood has always connected with people through sound. Now we want to expand the world of sound in ways that only Kenwood can,
listening to our customers and to the pulse of the coming age as we head toward a future of shared discovery, inspiration and enjoyment.
Analog measurements made per TIA/EIA 603 and specifications shown are typical.
Kenwood reserves the right to change specifications without prior notice or obligation.
FleetSync®is a registered trademark of Kenwood Corporation.
LTR®is a registered trademark of Transcrypt International.
AMBE+2TM is a trademark of Digital Voice Systems Inc.
Windows®is a registered trademark of Microsoft Corporation.
NXDN®is a trademark of Kenwood Corporation and Icom Inc.
NEXEDGETMis a trademark of Kenwood Corporation.
footnotes from Front:
1Requires NX subscriber unit PC Serial Interface compatible software application (e.g Kenwood AVL
& Dispatch Messaging software) or hardware (e.g. console).
2These trun ed features are primarily system programming and operational dependent. Priority
Monitor also requires NX subscriber settings.
JQA-QMA1205