Keurig B150 Series User manual

NOTE: The B150 Brewer is designed to ll in 90 seconds.
Depending on water pressure and voltage variations
the brewer may time out during ll. If this occurs just
ip the on/off switch – restarting the brewer.
Remove the Cold Water Tank from the Brewer.
2
Turn the B150 Brewer right side up. Press on one end of
the Base Plate to release and remove.
4
Turn the Brewer on its left side and remove the 2 high-
lighted screws (Screw A)- reserve the 2 screws for later
use when attaching the Direct Plumb Kit.
3
Make sure to disconnect the brewer from
AC power supply and drain the internal
Hot Water Tank if previously lled.
1
OVER
B150 Direct Plumb Kit Installation
Quick Start Guide

The Brewer should take 90 seconds to fill. However,
depending on water pressure and voltage variations
the brewer may time out during ll and shut down. This
is normal. If this occurs just ip the “On/Off” switch,
the brewer will re-start and it will complete the ll.
1 0
Remove the Connector Cover on the side of the Brewer
with a screw driver- Reserve the screw (Screw B) for
later use when re-attaching the Connector Cover.
5
Replace the Connector Cover with a screw driver and
the reserved screw (Screw B). Screw in the Connector
Cover until it is ush with the side of the unit.
7
Connect the B150 to AC power and a filtered water
supply. Turn the Brewer “On”.
9
Set the B150 Direct Plumb Kit on the Base and plug-in
the electrical connection from the Direct Plumb Kit to
the Brewer.
6
Carefully turn the brewer on its left side and re-insert
the 2 reserved screws (Screw A), securing the Plumb Kit
to the Base.
8
p/n 60-201188-000 Rev A