Keurig K-SELECT User manual

Let’s get
brewing.
Quick Start Guide

1.
2. For household use only.
3. Do not use distilled water.
4. Scalding may occur if the handle is
opened during the brewing process.
5. Do not touch hot surfaces. Use handles or
knobs.
6. To protect against fire, electric shock, and
injury to persons do not immerse appliance,
cord, or plugs in water or other liquid.
7. Close supervision is necessary when any
appliance is used by or near children 12 years
or younger.
8. Unplug from outlet when not in use and
before cleaning. Allow to cool before putting
on or taking off parts, and before cleaning the
appliance.
9. Do not operate any appliance with a
damaged cord or plug or after the appliance
malfunctions, or has been damaged in any
manner. The appliance should be returned
to the nearest authorized service facility
for examination, repair, or adjustment if
applicable or contact Keurig customer service.
When using electrical appliances, basic safety precautions should always be followed,
including the following:
10. The use of accessory attachments not
authorized by the appliance manufacturer
may result in fire, electric shock, or injury to
persons.
11. Do not use outdoors.
12. Do not let cord hang over edge of table or
counter, or touch hot surfaces.
13. Do not place on or near a hot gas or electric
burner, or in a heated oven.
14. Always attach plug to appliance first (if not
permanently attached), then plug cord into the
wall outlet. To disconnect, turn any control to
″off″ then remove plug from wall outlet.
15. Do not use appliance for other than intended
use.
16. Use brewer in upright position only. Allow
brewer to cool (90 min) prior to turning it in
any position other than upright.
17. Do not immerse brewer in water.
18.
For detailed brewer cleaning and maintenance
instructions, videos, and the full Use & Care Guide
visit support.keurig.com.

WARNING !
RISK OF FIRE OR ELECTRIC
SHOCK DO NOT OPEN
WARNING, TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
1. WARNING: Keep all plastic bags away from
children.
2. CAUTION: Keurig® recommends using only
Keurig® My K-Cup® Reusable Coffee Filter and
Keurig® K-Cup® pods in this appliance. The use
of non-Keurig® pods or accessories may cause
brewer malfunction or injury.
3. CAUTION: There are two sharp needles
that puncture the K-Cup® pod, one above
the K-Cup® pod holder and the other in the
bottom of the K-Cup® pod holder. To avoid risk
of injury, be aware of the needle locations.
4. CAUTION: There is extremely hot water under
pressure in the K-Cup® pod holder during the
brew process. To avoid risk of injury do not
lift the handle or otherwise open the handle
during the brew process.
5. POWER CORD INSTRUCTIONS:
a. A short power-supply cord is provided to
reduce risks resulting from becoming entangled
in or tripping over a longer cord.
b. Longer detachable power-supply cords or
extension cords are available and may be used
if care is exercised in their use.
c. If a long detachable power-supply cord or
extension cord is used:
i. The marked electrical rating of the
detachable power-supply cord or extension
cord should be at least as great as the
electrical rating of the appliance.
ii. If the appliance is of the grounded type, the
extension cord should be a Grounding type
3-wire cord.
iii. The longer cord should be arranged so that
it will not drape over the counter top or table
top where it can be pulled on by children or
tripped over.
6. CAUTION: HOT COCOA/OTHER NON-
COFFEE PODS: Immediately after using a
hot cocoa/other non-coffee pod, run a hot
water brew cycle without a pod to avoid the
possibility of clogging the exit needle. DO NOT
assume the next user will do this.

Before You Brew
Rinse & Fill
Remove the water reservoir lid, then lift the reservoir
straight up to remove it.
If you have a Keurig® Water Filter, install it now. Refer
to your Water Filter Starter Kit for instructions.
Rinse reservoir with fresh water and fill to the
MAX fill line.
Replace water reservoir, making sure the lock tab
engages with the brewer. Replace lid.
NOTE: Do not use distilled water.
Plug & Place
Remove packing tape from brewer and plug into
a grounded outlet.
Place a large mug (12oz minimum) on the drip
tray plate.
AutoOff
Strong
AddWater
Clean
MAX.
Strong
AutoOff
AddWater
Descale
AutoOff
Strong
AddWater
Descale

Power On
Press power button — the green power light and
Auto Off light will illuminate.
The brewer will automatically begin heating the
water. This will take about 3 minutes. Once the
heating sound stops, the brewer is ready.
Cleansing Brew
Lift and lower the handle. Do not insert a K-Cup®
pod. The four brew buttons and the Strong
button will blink. Press the small cup button to
start a cleansing brew. Pour the hot water into
the sink.
The one-time setup process is now complete
and you are ready to brew!
NOTE: Between brew cycles, the brewer may take about a minute to reheat.
Auto Off
Add Water
Descale
Strong
Strong
AutoOff
AddWater
Descale
3
Small Cup
6oz
Large Mug
10oz
Small Mug
8oz
Travel Mug
12oz
Strong

Brew & Enjoy!
Select your brew size — for bolder coffee, press the
Strong button before selecting your brew size. The
brew size and Strong button, if selected, will remain
illuminated while brewing — about 1 minute.
The brewer will be ready to brew another cup in
about a minute.
NOTE: After 60 seconds, the brew buttons will be disabled. To re-activate,
lift and lower the handle completely.
CAUTION: While brewing, there is extremely hot water in the K-Cup® pod
holder. To avoid injury, do not lift the handle during the brewing process.
Brew Your First Cup
Place Mug & Pod
Place a mug on the drip tray plate. If using a
travel mug, remove the drip tray and place the
mug on the drip tray base. Lift the handle and
place a K-Cup® pod in the K-Cup® pod holder.
Lower the handle completely to close the lid.
Do not remove the foil lid on the K-Cup® pod.
High Altitude Brewing: While holding the brewer
handle up, push down slowly on the K-Cup® pod
in the pod holder until the bottom of the K-Cup®
pod is punctured by the exit needle.
NOTE: To enable the High Altitude Mode, see the Use & Care Guide on
support.keurig.com.
Strong
AutoOff
AddWater
Descale
Small Cup
6oz
Large Mug
10oz
Small Mug
8oz
Travel Mug
12oz
Strong
Strong
AutoOff
AddWater
Descale

Brewer Features
Strong Brew increases your coffee strength and
intensity. For bolder coffee, press the Strong
button and select your brew size.
Smart Start heats then brews in one simple
process. No need to wait for the brewer to heat
before selecting brew size. Power on your
brewer, place mug, insert a K-Cup® pod, and
lower the handle. Then, select your brew size.
The brewer will heat, then automatically begin
brewing.
Auto Off automatically turns your brewer off
2 hours after the last brew for energy savings.
To disable the Auto Off feature:
1. Power the brewer off while it is plugged in.
2. Press and hold the Strong and the 10oz
Large Mug buttons for 3 seconds - the
green Auto Off light will turn off.
3. Power the brewer on - the green Auto Off
light will no longer be illuminated.
To enable the Auto Off feature, repeat steps 1-3.
The green Auto Off light will illuminate.
Caring for your Brewer
Regular cleaning keeps your brewer running
smoothly. Always be sure to turn off and unplug
your brewer before cleaning. For detailed brewer
cleaning instructions and videos visit
support.keurig.com. Beyond these recommended
cleaning instructions, this brewer is not user-
serviceable. For service, please refer to the
Warranty included with your brewer.
Water Reservoir
The water reservoir lid and water reservoir should
be cleaned periodically. Clean in a dishwasher
(top rack only) or hand wash. To hand wash, use
a damp, soapy, non-abrasive cloth. Rinse the
reservoir thoroughly after cleaning. This will
ensure that no cleaning solutions remain in the
area as they may contaminate the water supply.
After rinsing, fill the reservoir with clean water
and return it to the brewer. Do not dry the inside
of the water reservoir with a cloth as lint may
remain.

Exit Needle
Remove the pod holder
assembly and detach the
funnel. Locate the exit
needle on the inside bottom
of the K-Cup® pod holder.
Insert a straightened paper
clip into the exit needle to
loosen any coffee grounds.
Entrance Needle
Lift the brewer handle and locate the entrance
needle on the underside of the lid. To clean both
holes in the needle, hold the brewer handle in the
upward position and with your other hand,
carefully insert a straightened paper clip into both
holes. Gently move it around to loosen any coffee
grounds. Lower the handle completely and run
two water-only brew cycles. Do not insert a
K-Cup® pod.
CAUTION: There are sharp needles that puncture
the K-Cup® pod above the K-Cup® pod holder and
in the bottom of the K-Cup® pod holder. To avoid
risk of injury, do not put your fingers in the K-Cup®
pod holder.
Have questions? We’re here to help. Visit keurig.com/new for troubleshooting
videos, maintenance recommendations, and the full Use & Care Guide.
Still need help? Give us a call at 1-866-901-BREW (2739)
DC0000001136 REV E
Coffeehouse taste
in your own home.
FIND YOUR PERFECT POD
With over 70 brands and hundreds
of varieties, find your match at
keurig.com/new